Crankshaft Front Seal
Usage:
Remove Crankshaft Front Seal
start by:
a) remove crankshaft pulley and vibration damper
1. Remove the crankshaft front seal, using tool group (A).
Install Crankshaft Front Seal
1. Install the crankshaft front seal, using tool group (A).
2. Put clean SAE 30 oil on the lip of the seal and on the crankshaft. Put the seal in position on the crankshaft with the spring edge of lip in the direction of the rear of the engine.
3. Hold the seal installer ring (1) and pusher plate (2) in position on the crankshaft. Install the bolt (3) and washer (4).
4. Tighten bolt (3) until pusher plate (2) makes contact with the end of the crankshaft.
end by:
a) install crankshaft pulley and vibration damper
Caterpillar Information System:
G333C ENGINE Crankshaft Pulley And Vibration Damper
G333C ENGINE Crankshaft Main Bearings
G333C ENGINE Connecting Rod Bearings
G333C ENGINE Oil Pan Plate
G333C ENGINE Oil Pump
G333C ENGINE Oil Pan
G333C ENGINE Engine Water Pump
G333C ENGINE Auxiliary Water Pump Drive
G333C ENGINE Auxiliary Water Pump
G333C ENGINE Oil Cooler And Filter Base
G333C ENGINE Governor Drive
G333C ENGINE Governor
G333C ENGINE Timing Gear Cover
G333C ENGINE Magneto Drive
G333C ENGINE Camshaft
G333C ENGINE Timing Gears And Plate
G333C ENGINE Spark Plugs
G333C ENGINE Spark Plug Adapters
G333C ENGINE Differential Pressure Regulator
G333C ENGINE Air Cleaner Housing
G333C ENGINE Turbocharger
G333C ENGINE Exhaust Manifold
G333C ENGINE Carburetor
G333C ENGINE Gas Pressure Regulator