1982/06/21 Caterpillar


Different Pipe Plug In Turbocharger Turbine Housing Prevents Contact With Oil Filter{1052,1318}

Usage:


3208 Marine Engines (1Z)

Description of Change: A different pipe plug is now used in the turbine housing of turbochargers for 3208 Marine Engines (1Z). The new plug has a thread which permits it to be installed deeper into the hole, so the top of the plug is even with the housing around the hole. Formerly, the top of the plug was above the surface of the housing, and some engines were found where the plug next to the oil filter made contact with the filter assembly.

Adaptable As: The new 9L8412 Plug can be installed as a direct replacement for the former 1B5174 Pipe Plug in either the later 7N6181 Turbine Housing Assembly, or the earlier 6N574 Turbine Housing which is canceled. On any engines where contact is found between the pipe plug and the oil filter assembly, install the new pipe plug.

Caterpillar Information System:

1982/06/21 Engine Ground Straps Necessary To Prevent Electrical Discharge Damage To Crankshaft Bearings{1202,1203,1400,1405}
1982/06/21 Hose Presses Can Now Be Used To Install JIC Couplings{0623,7554,0624}
1982/06/14 New Address For Repair Of Diagnostic Tools{0650}
1982/06/14 Improvements Made To Input Shaft Group{3303}
1982/06/14 Stronger Turbine Wheel Used In Turbocharger Shaft And Wheel Assemblies{1053,1052}
1982/06/07 Identification Numbers For Caterpillar Partial Machines{0300}
1982/06/07 Use Correct Torque On Hydraulic Fittings{7554,5057}
1982/06/07 List Of Main And Connecting Rod Bearings Currently Available{1203,1219,1230,1226,1227}
1982/06/07 Separate Valve Stem Gauges Available{0653,1000}
1982/05/31 Separate Serial Numbers For 3208 Remanufactured Engines {1000}
1982/05/31 Improved Water Separator Group Used {1263}
1982/05/24 New Seal Used In Turbocharger Mounting; Check Mount Casting For Clearance{1052}
1982/06/21 New Piston Group Has A Thicker Top Ring{1215,1214,1213,1225,1226,1227}
1982/06/28 6V6124 Calibration Coil Available To Calibrate And Check 6V4910 AC/DC Clamp-On Ammeter{0651}
1982/06/28 Replacement Of Brush Holder Pins In Delco-Remy Electric Starting Motors{1453}
1982/06/28 Explanation For "Notice" And "Warning" In Service Publications{0374,0375}
1982/06/28 Caterpillar Recommends Against The Use Of Alcohol Mist Injection Systems{1050,1250}
1982/07/05 Use Correct Torque To Prevent Broken Rocker Arm Shafts{1102}
1982/07/05 Water Cooled Turbocharger Now Used{1052,1307,1380}
1982/07/05 New Crankshaft Wear Sleeve For Engines With Lip-Type Seals{1160,1161}
1982/07/05 Information Available For The Installation Of Inserts In Cylinder Blocks And Spacer Plates{1217,1201,0664}
1982/07/05 Service Parts Available For The 6V200 Hydraulic Wrench{0623}
1982/07/05 Decal For Track Press Information Revised{0624,4169,4170,4175}
1982/07/12 New Gear Type Pump Primes Itself At Start-Up{3310,3314}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.