Valve Lash Is Excessive
- Lubrication is inadequate
- Valve lash is out of adjustment
- Valve train components
Note: The procedures have been listed in order of probability. Complete the procedures in the order of the listed test steps.
Show/hide table
| Troubleshooting Test Steps | Values | Results |
|---|---|---|
1. Check for Adequate Lubrication A. Check the lubrication in the valve compartment. Ensure that there is adequate engine oil flow in the valve compartment. The passages for the engine oil must be clean. |
Lubrication |
Result: The lubrication system is OK. Proceed to the Test Step 2. Result: The lubrication system is NOT OK. Repair: Restore adequate oil flow. If the problem is not resolved, proceed to Test Step 2. |
2. Check the Valve Lash |
Lash |
Result: The lash setting is OK. Proceed to the next step. Result: The lash setting is NOT OK. Repair: Adjust the engine valve lash. Refer to the engine Systems Operation/Testing and Adjusting manual. If the problem is not resolved, proceed to Test Step 3. |
3. Inspect the Valve Train Components A. Inspect the following components of the valve train: - Rocker arms - Valve lifters - Camshaft - Valve stems - Rocker shafts Check the components for the following conditions: - Straightness - Abnormal wear - Excessive wear - Cleanliness |
Components |
Result: A component is NOT OK. Repair: Replace parts, if necessary. Adjust the engine valve lash. Refer to the engine Systems Operation/Testing and Adjusting manual. Note: If the camshaft is replaced, then replacing the valve lifters is mandatory. |
Caterpillar Information System:
WS063, WSF063 and WSP063 Well Stimulation Pumps Gearbox (Input Drive) - Remove and Install
CX31 and CX31 HT On-Highway Transmissions (Cat Truck) Oil Filter (Transmission)
C175-16 Petroleum Engines Engine Oil Pressure - Test
3512C Engine Engine Oil Pan - Remove and Install
CX31 and CX31 HT On-Highway Transmissions (Cat Truck) Relief Valve (Torque Converter Inlet) Pressure - Test
CX31 and CX31 HT On-Highway Transmissions (Cat Truck) Relief Valve (Transmission Hydraulic Control) - Test and Adjust
3512C Engine Engine Oil Filter Housing - Remove and Install
3512C Engine Engine Oil Pump - Remove and Install
326F and 330F Excavator Machine Systems Relief Valve (Pilot)
WS063, WSF063 and WSP063 Well Stimulation Pumps Seal (Crosshead Rod) - Remove and Install
C8.7 Marine Engine Coolant Level - Check
3512C Engine Engine Oil Cooler - Remove and Install
3512C Engine Engine Oil Pan - Disassemble
Differences in Appearance of Cat ® Reman Parts when Compared to New Parts {1000, 1250} Differences in Appearance of Cat ® Reman Parts when Compared to New Parts {1000, 1250}
C8.7 and C12.9 Marine Engines Cylinder Is Noisy
C4.4 Marine Generator Set Magnetic Pickup
C4.4 Marine Generator Set Engine Oil Pan Drain Valve
C175-16 Petroleum Engines Air Shutoff
C8.7 and C12.9 Marine Engines Electronic Service Tool Does Not Communicate
WS063, WSF063 and WSP063 Well Stimulation Pumps Crosshead - Remove and Install
WS063, WSF063 and WSP063 Well Stimulation Pumps Crankshaft (Pump) - Remove and Install
3512C Marine Auxiliary Generator Set Engines with Dynamic Gas Blending Engine Monitoring System
3512C Marine Auxiliary Generator Set Engines with Dynamic Gas Blending Fuel Pressure - Gas System
3512C Engine Engine Oil Pan - Assemble