Specifications
Parameter     | Value     |
Fuel Supply Pressure     | 83 to 586 kPa (12 to 85 psig) (1)     |
Fuel Pressure to Control Valve     | 10.3 to 24.1 kPa (1.5 to 3.5 psig)     |
( 1 ) | The recommended supply pressure range is 30-35 psig. |
Introduction
Use this procedure to check the regulated fuel pressure. Make sure that the fuel supply pressure is correct.
Required Tools
Required Tools     | |
Qty     | Part Number     |
1     | 1U-5470 Engine Pressure Gp     |
1     | 8T-5160 Gas Regulator Setting Tool     |
Illustration 1 | g01192577 |
1U-5470 Engine Pressure Group (1) Pressure indicators (2) Zero adjustment screw (3) Pressure indicator (4) Pressure tap (5) Pressure indicator |
This tool group has an indicator that is used to read the pressure in the fuel lines. The Special Instruction, SEHS8907 is with the tool group.
Test Preparation - Fuel Pressure to Control Valve
NOTICE |
---|
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component. |
Illustration 2 | g03671390 |
(6) Gas line (7) Gas pressure sensor (8) Fuel control valve (9) Gas Shutoff Valve (GSOV) |
- Turn off the main gas valve.
- De-energize GSOV (9) .
- Slowly remove gas pressure sensor (7) from gas line (6) .
- Install a fitting into gas line (6). Connect the 1U-5470 Engine Pressure Gp to the fitting. Refer to Illustration 1.
Test Procedure - Fuel Pressure to Control Valve
NOTICE |
---|
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component. |
- Open the main gas valve.
- Energize the GSOV.
- Check the engine gas pressure to the fuel control valve. If, the pressure is not 10.3 to 24.1 kPa (1.5 to 3.5 psig) refer to Adjustment Procedure - Fuel Pressure to Fuel Control Valve.
Adjustment Procedure - Fuel Pressure to Fuel Control Valve
Illustration 3 | g03333365 |
(10) Bolt (11) Cover |
- Remove cover (11), and install the correct tools, from the 8T-5160 Gas Regulator Setting Tool, for pressure setting adjustment.
- Adjust bolt (10) to achieve desired fuel pressure to the fuel control valve.
- After desired pressure is reached, install cap (11) .