Camshaft Bearings - Remove
Show/hide table
Required Tools | |||
Tooling | Part Number | Description | Qty |
A | 8S-2241 | Camshaft Bearing Tool Group | 1 |
8H-0684 | Ratchet Wrench | 1 |
Start By:
- Remove the oil pan plate. Refer to Disassembly and Assembly, "Oil Pan Plate - Remove and Install" for the engine that is being serviced.
- Remove the timing gear plate. Refer to Disassembly and Assembly, "Timing Gear Plate - Remove and Install" for the engine that is being serviced.
- Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove" for the engine that is being serviced.
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove" for the engine that is being serviced.
- Use Tooling (A) in order to remove the camshaft bearings.
Show/hide table
Illustration 1 | g01003834 |
Show/hide table
Illustration 2 | g01003838 |
Caterpillar Information System:
C11, C13 and C15 On-highway Engines 0105-04 Intake Manifold Air Temperature voltage low (38)
C11, C13 and C15 On-highway Engines 0105-03 Intake Manifold Air Temperature voltage high (38)
Bench Test Procedure for Hydraulic Piston Pumps{5070} Bench Test Procedure for Hydraulic Piston Pumps{5070}
G3500 Engines MID 018 - CID 0523 - FMI 11 No A/F Ratio Engine Speed Sensor **Shutdown**
G3304 and G3306 Engines Cylinder Liner - Install
C3.3 Industrial Engine Engine Warm-up
G3500 Engines MID 018 - CID 0550 - FMI 02 Noisy or Loss of Oxygen Signal
G3520C and G3520E Generator Set Engines Crankshaft - Install
G3520C and G3520E Generator Set Engines Crankshaft - Remove
2003/06/01 Removal of Elbow Improves the Reliability of the Cooling System in an Industrial Application {1380}
XQP60 and XQP100 Rental Generator Sets Fuel System - Prime
3500B Series II Marine Engines Direct Fuel Control Mode
G3304 and G3306 Engines Camshaft Bearings - Install
3406C Marine Auxiliary Generator Set Plate Locations and Film Locations
G3304 and G3306 Engines Crankshaft - Remove
3500 Engines Fuel Filter Housing - Remove
3500 Engines Fuel Filter Housing - Install
G3304 and G3306 Engines Crankshaft - Install
G3520C and G3520E Generator Set Engines Piston and Connecting Rods - Remove
G3520C and G3520E Generator Set Engines Piston and Connecting Rods - Install
2003/06/01 Improved Radiator for the Generator Set Engine {1353}
G3500 Engines MID 018 - CID 0551 - FMI 01 Oxygen Sensor not connected to buffer
G3500 Engines MID 018 - CID 0552 - FMI 11 Engine Speed present during an O2 calibration
3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Oil Bypass Valve - Remove and Install