Valve Lifters
Usage:
Remove & Install Valve Lifters
Start By:
a. remove spacer plate
1. Use a magnet (1) to remove valve lifters (2). Put identification marks on lifters for installation purposes.
2. Check the diameter of the valve lifter. The diameter of the valve lifter (new) must be 33.287 ± 1.311 mm (1.3105 ± .0516 in). The bore in the block for new valve lifters must be 33.388 ± 0.025 mm (1.3145 ± .0010 in). The maximum permissible clearance between the lifter and the bore for the valve lifter (worn) is 0.30 mm (.012 in).
3. Put 4C-5593 Anti-Seize Compound on the valve lifters and camshaft lobes. Install the valve lifters in original positions in the cylinder block.
End By:
a. install spacer plate
Caterpillar Information System:
3306B GENERATOR SET ENGINE Spacer Plate
3306B GENERATOR SET ENGINE Cylinder Head
3306B GENERATOR SET ENGINE Rocker Shaft Assembly & Push Rods
3306B GENERATOR SET ENGINE Valve Cover
3306B GENERATOR SET ENGINE Turbocharger
3306B GENERATOR SET ENGINE Turbocharger
3306B GENERATOR SET ENGINE Exhaust Manifold
3306B GENERATOR SET ENGINE Engine Oil Cooler
3306B GENERATOR SET ENGINE Fuel Filter & Base
3306B GENERATOR SET ENGINE Fuel Priming Pump & Base
3306B GENERATOR SET ENGINE Oil Filter Base
3306B GENERATOR SET ENGINE Oil Filter & Oil Filter Base
3306B GENERATOR SET ENGINE Inlet & Exhaust Valves
3306B GENERATOR SET ENGINE Valve Guides
3306B GENERATOR SET ENGINE Valve Seat Inserts
3306B GENERATOR SET ENGINE Pistons & Connecting Rods
3306B GENERATOR SET ENGINE Connecting Rod Bearings
3306B GENERATOR SET ENGINE Cylinder Pack
3306B GENERATOR SET ENGINE Crankshaft Main Bearings
3306B GENERATOR SET ENGINE Flywheel
3306B GENERATOR SET ENGINE Crankshaft Rear Seal & Wear Sleeve
3306B GENERATOR SET ENGINE Flywheel Housing
3306B GENERATOR SET ENGINE Oil Pan
3306B GENERATOR SET ENGINE Oil Pan Plate