Usage:
1. Unplug the connector and remove speed pickup (1) to prevent damage to the unit.
2. Install Tool (A) on the flywheel as shown and fasten a hoist.
3. Remove bolts (2) and flywheel (3). The weight of the flywheel is approximately 72 kg (160 lb).
4. If necessary, remove the ring gear from the flywheel with a hammer and punch.
NOTE: The following steps are for the installation of the flywheel.
| NOTICE |
|---|
The ring gear must be installed with the chamfered side of the teeth up as shown. This will put the chamfered side of the gear teeth toward the starter when the flywheel is installed so the starter will engage correctly. |
1. Heat ring gear (4) to a maximum temperature of 320° C (608° F). Install the ring gear on the flywheel.
2. Install Tooling (A) on the flywheel in the same position it was during removal.
NOTE: Install two 5/8 in-18 NF Guide Bolts in the crankshaft if necessary.
3. Make an alignment of timing mark (5) on the crankshaft and timing mark (6) on the flywheel. Hold flywheel (3) in position and install bolts (2). Tighten bolts (2) to a torque of 205 ± 27 N·m (151 ± 20 lb ft).
4. Remove Tool (A).
5. Install speed pickup (1). Hand tighten speed pickup (1) until it makes contact with the flywheel. Loosen speed pickup (1) 180 degrees (1/2 turn) after contacting the flywheel. Tighten the locknut on speed pickup (1) and connect wiring harness.