Valve Seat Inserts
Usage:
Remove & Install Valve Seat Inserts
Start By:
a. remove valves
Typical Example
1. Use Tooling (A) to remove the valve seat inserts from the cylinder head.
2. Clean and remove any rough places (burrs) from the valve seat bores.
NOTE: For reconditioning information of the cylinder head, see Service Training Meeting Guide, JEG02327.
NOTE: The following steps are for the installation of the valve seat inserts.
3. Lower the temperature (freeze) of the new valve seat inserts. Use Tooling (A) to install the new valve seat inserts. Do not increase the diameter of the extractor in the valve seat insert when the inserts is installed in the cylinder head.
End By:
a. install valves
Caterpillar Information System:
3306B GENERATOR SET ENGINE Valve Guides
3306B GENERATOR SET ENGINE Inlet & Exhaust Valves
3306B GENERATOR SET ENGINE Valve Lifters
3306B GENERATOR SET ENGINE Spacer Plate
3306B GENERATOR SET ENGINE Cylinder Head
3306B GENERATOR SET ENGINE Rocker Shaft Assembly & Push Rods
3306B GENERATOR SET ENGINE Valve Cover
3306B GENERATOR SET ENGINE Turbocharger
3306B GENERATOR SET ENGINE Turbocharger
3306B GENERATOR SET ENGINE Exhaust Manifold
3306B GENERATOR SET ENGINE Engine Oil Cooler
3306B GENERATOR SET ENGINE Fuel Filter & Base
3306B GENERATOR SET ENGINE Pistons & Connecting Rods
3306B GENERATOR SET ENGINE Connecting Rod Bearings
3306B GENERATOR SET ENGINE Cylinder Pack
3306B GENERATOR SET ENGINE Crankshaft Main Bearings
3306B GENERATOR SET ENGINE Flywheel
3306B GENERATOR SET ENGINE Crankshaft Rear Seal & Wear Sleeve
3306B GENERATOR SET ENGINE Flywheel Housing
3306B GENERATOR SET ENGINE Oil Pan
3306B GENERATOR SET ENGINE Oil Pan Plate
3306B GENERATOR SET ENGINE Oil Pump
3306B GENERATOR SET ENGINE Water Temperature Regulator
3306B GENERATOR SET ENGINE Water Pump