Valve Guides
Usage:
Remove & Install Valve Guides
Start By:
a. remove valves
1. Remove the valve guides from the cylinder head with Tool (A).
2. Put clean engine oil on the outside diameter of the valve guide. Install the valve guide with Tooling (A) and (B). Dimension "X" from the top of the valve guide to the cylinder head is 22.23 ± .025 mm (.875 ± .010 in).
3. The inside diameter of a new valve guide after installation must be a minimum of 9.456 mm (.3723 in). The maximum inside diameter for a worn guide must not be more than 9.581 mm (.3772 in).
End By:
a. install valves
Caterpillar Information System:
3306B GENERATOR SET ENGINE Inlet & Exhaust Valves
3306B GENERATOR SET ENGINE Valve Lifters
3306B GENERATOR SET ENGINE Spacer Plate
3306B GENERATOR SET ENGINE Cylinder Head
3306B GENERATOR SET ENGINE Rocker Shaft Assembly & Push Rods
3306B GENERATOR SET ENGINE Valve Cover
3306B GENERATOR SET ENGINE Turbocharger
3306B GENERATOR SET ENGINE Turbocharger
3306B GENERATOR SET ENGINE Exhaust Manifold
3306B GENERATOR SET ENGINE Engine Oil Cooler
3306B GENERATOR SET ENGINE Fuel Filter & Base
3306B GENERATOR SET ENGINE Fuel Priming Pump & Base
3306B GENERATOR SET ENGINE Valve Seat Inserts
3306B GENERATOR SET ENGINE Pistons & Connecting Rods
3306B GENERATOR SET ENGINE Connecting Rod Bearings
3306B GENERATOR SET ENGINE Cylinder Pack
3306B GENERATOR SET ENGINE Crankshaft Main Bearings
3306B GENERATOR SET ENGINE Flywheel
3306B GENERATOR SET ENGINE Crankshaft Rear Seal & Wear Sleeve
3306B GENERATOR SET ENGINE Flywheel Housing
3306B GENERATOR SET ENGINE Oil Pan
3306B GENERATOR SET ENGINE Oil Pan Plate
3306B GENERATOR SET ENGINE Oil Pump
3306B GENERATOR SET ENGINE Water Temperature Regulator