MID 036 - CID 0248 - FMI 09 Cat Data Link not communicating
Conditions Which Generate This Code:
The battery voltage to the Electronic Control Module (ECM) has been above 9 VDC for the last two seconds. The engine is not cranking. Communications with the VIMS and/or the VIDS has not been established for six seconds. Communication was lost for two or more seconds. The CID-FMI is logged in memory.
System Response:
The CID-FMI may be viewed on a display module or Caterpillar Electronic Technician (ET). The features which receive inputs from the Cat Data Link are disabled.
Test Step 1. Perform the following diagnostic procedure: "Cat Data Link"
Results:
- OK - STOP
- REPAIRED, OK - STOP
Caterpillar Information System:
Generator Service Literature Index{4450} Generator Service Literature Index{4450}
365B Excavator Main Menu
3408E and 3412E Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3064 and 3066 Engines for Caterpillar Built Machines Basic Engine
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Cylinder Cycle Time - Check
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Heating and Air Conditioning Unit - Install
311B, 312B and 312B L Excavators Quick Coupler - Lubricate - If Equipped
312B Excavator Machine Systems Main Hydraulic Pump and Pump Drive Coupling - Remove
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Heating and Air Conditioning Unit - Remove
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator Cycle Time - Check
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic System Air - Purge
M312 and M315 Excavators Machine Electronic Control System Controller - Replace
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Undercarriage Frame - Remove
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Track Adjuster - Disassemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Final Drive - Install
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Final Drive - Remove
3064 and 3066 Engines for Caterpillar Built Machines Pinion Clearance - Adjust
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
MP-15, MP-20, MP-30 and MP-40 Multi Processors Gerotor Motor
MP-15, MP-20, MP-30 and MP-40 Multi Processors Swivel
312B Excavator Machine Systems Main Hydraulic Pump and Pump Drive Coupling - Install
MP-15, MP-20, MP-30 and MP-40 Multi Processors Control Manifold - Crossover Relief Valve
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Cylinder
365B and 365B Series II Excavators and 365B Series II Front Shovel Machine System Specifications Final Drive