Inlet and Exhaust Valve Guides - Remove and Install
Show/hide table
所需工具 | |||
---|---|---|---|
工具 | 零件号 | 零件说明 | 数量 |
A | 9U-7349 | 气门导管冲头 | 1 |
开始:
- 拆下进气阀和排气阀。 请参阅拆解和组装, "进气门与排气门 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 利用工具 (A) 和手锤将进气和排气门导管从缸盖上拆下。
Show/hide table
图 1 | g00569544 |
Show/hide table
所需工具 | |||
---|---|---|---|
工具 | 零件号 | 零件说明 | 数量 |
A | 9U-7349 | 气门导管冲头 | 1 |
B | 5P-2396 | 衬套 | 1 |
- 在气门导管外周上涂抹干净的机油。 利用工具 (A) 和 (B) 安装气门导管。
- 安装气门导管,直到气门导管伸出缸盖表面
32.3 ± 0.8 mm (1.27 ± 0.03 in) 为止。 有关更多有关进气门导管和排气门导管的信息,请参阅技术规格, "缸盖气门"。
Show/hide table
图 2 | g01082857 |
结束:
- 安装进气门和排气门。 请参阅拆解和组装, "进气门与排气门 - 拆卸和安装"。
Caterpillar Information System:
3064 and 3066 Engines for Caterpillar Built Machines Basic Engine
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Cylinder Cycle Time - Check
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Heating and Air Conditioning Unit - Install
311B, 312B and 312B L Excavators Quick Coupler - Lubricate - If Equipped
312B Excavator Machine Systems Main Hydraulic Pump and Pump Drive Coupling - Remove
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Heating and Air Conditioning Unit - Remove
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator Cycle Time - Check
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic System Air - Purge
M312 and M315 Excavators Machine Electronic Control System Controller - Replace
3512 and 3516 EUI Engines for 784B, 785B, 789B and 793B Off-Highway Trucks MID 036 - CID 0091 - FMI 08 Throttle Position signal abnormal
MP-15, MP-20, MP-30 and MP-40 Multi Processors Work Tool Troubleshooting
M312 and M315 Excavators Machine Electronic Control System General Calibration Information
365B Excavator Main Menu
Generator Service Literature Index{4450} Generator Service Literature Index{4450}
3512 and 3516 EUI Engines for 784B, 785B, 789B and 793B Off-Highway Trucks MID 036 - CID 0248 - FMI 09 Cat Data Link not communicating
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Undercarriage Frame - Remove
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Track Adjuster - Disassemble
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Final Drive - Install
365B, 365B Series II, 365BL and 365BL Series II Excavators Machine Systems Final Drive - Remove
3064 and 3066 Engines for Caterpillar Built Machines Pinion Clearance - Adjust
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
MP-15, MP-20, MP-30 and MP-40 Multi Processors Gerotor Motor
MP-15, MP-20, MP-30 and MP-40 Multi Processors Swivel
312B Excavator Machine Systems Main Hydraulic Pump and Pump Drive Coupling - Install