Fuel Control Valve - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn off the gas supply.
Show/hide table
Illustration 1 g00597612 - Disconnect tube (2).
- Remove clip (5) and disconnect tube (7).
- Remove bolts (1), the nuts, and the spacers.
- Remove gas regulator (6) and the gasket.
Note: The plate that is on the end of the gas regulator is for shipping purposes. The customer will remove the plate.
- Remove fuel line (3) and fuel control valve (4).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Apply 5P-3413 Pipe Sealant to all pipe threads prior to assembly.
Show/hide table
Illustration 2 g00597612 - Install fuel control valve (4) and fuel line (3).
- Install the gasket and gas regulator (6). Install bolts (1), the spacers, and the nuts.
- Connect tube (7) and install clip (5).
- Install tube (2).
- Turn on the gas supply.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 3 Alarm Module Control Voltage Above Normal - Test
3500B Engines and 3500 Engines with EUI Option Engine Control Switch (ECS)
G3500 Engines Fuel Control Actuator - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 331 FMI 2 Switch (Engine Control) Incorrect Signal - Test
G3500 Engines Electronic Sensor - Remove and Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Gear Group (Front)
G3500 Engines Carburetor - Assemble - High Pressure
3034 Engine for Caterpillar Built Machines Turbocharger - Install
3500B Engines and 3500 Engines with EUI Option Emergency Stop Switch
G3500 Engines Carburetor - Disassemble - High Pressure
G3500 Engines Carburetor - Assemble - High Pressure
3500B Engines Air Starting Motor - Remove
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 4 Alarm Module Control Voltage Below Normal - Test
G3500 Engines Gas Pressure Regulator Solenoid - Remove and Install
G3606 and G3608 Engines Actuator (Hydrax) - Remove
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Cylinder Head - Install
3500B Engines Air Starting Motor - Install
3500B Engines Air Starting Motor - Disassemble
G3500 Engines Gas Pressure Regulator - Remove - Low Pressure
G3500 Engines Gas Pressure Regulator - Install - Low Pressure
G3500 Engines Gas Pressure Regulator - Remove - High Pressure
345B Excavator and 345B Material Handler Machine System Specifications Solenoid Valve (Counterweight Control)
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 336 FMI 2 Switch (Engine Control) Incorrect Signal - Test
G3500 Engines Gas Pressure Regulator - Install - High Pressure