Turbocharger - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put gasket (7) and turbocharger (2) in position on the exhaust manifold.
Show/hide table
Illustration 1 | g00597180 |
- Install three nuts (6) that fasten turbocharger (2) to the exhaust manifold. Tighten the nuts to a torque of 22 N·m (16 lb ft).
Show/hide table
Illustration 2 | g00597025 |
- Tighten hose clamp (5) for the oil drain line.
- Connect oil line (4) to turbocharger (2) .
- Slide the hoses toward turbocharger (2) and tighten hose clamps (3) and (1) .
Show/hide table
Illustration 3 | g00596955 |
Caterpillar Information System:
3500B Engines and 3500 Engines with EUI Option Emergency Stop Switch
G3500 Engines Carburetor - Disassemble - High Pressure
G3500 Engines Carburetor - Assemble - High Pressure
3500B Engines Air Starting Motor - Remove
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Front Housing and Covers
G3606 and G3608 Engines Hydraulic Tank (Hydrax) - Remove and Install
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Harness Code - Troubleshoot
G3500 Engines Carburetor - Disassemble - High Pressure
G3606 and G3608 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - High Pressure
G3500 Engines Carburetor - Assemble - High Pressure
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Gear Group (Front)
G3500 Engines Electronic Sensor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 331 FMI 2 Switch (Engine Control) Incorrect Signal - Test
G3500 Engines Fuel Control Actuator - Remove and Install
3500B Engines and 3500 Engines with EUI Option Engine Control Switch (ECS)
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 3 Alarm Module Control Voltage Above Normal - Test
G3500 Engines Fuel Control Valve - Remove and Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 4 Alarm Module Control Voltage Below Normal - Test
G3500 Engines Gas Pressure Regulator Solenoid - Remove and Install
G3606 and G3608 Engines Actuator (Hydrax) - Remove
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Cylinder Head - Install