Carburetor - Disassemble - High Pressure
Start By:
- Remove the carburetor.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove adapter (1) and the gasket from throttle assembly (2).
Show/hide table
Illustration 2 g00597405 Typical example - Remove screws (10) that hold mixer housing (3) to throttle assembly (2).
- Separate mixer housing (3) and throttle assembly (2).
- Remove washer (6), jet (5), and O-ring seal (4) from throttle assembly (2).
- Remove the screw and valve (7) from mixer housing (3).
- Remove O-ring seal (8).
- Remove the two screws and piston (9) from mixer housing (3).
- Remove screws (18) and cover (17) from mixer housing (3).
- Remove spring (16) and air valve assembly (12) from mixer housing (3).
- Remove O-ring seal (11) from air valve assembly (12).
- Remove the screws, plate (15), diaphragm (14), and shaft (13) from air valve assembly (12).
- Repeat Steps 1 through 11 for the second carburetor.
Show/hide table
Illustration 1 | g00597403 |
Typical example |
Caterpillar Information System:
G3500 Engines Carburetor - Assemble - High Pressure
3500B Engines Air Starting Motor - Remove
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Front Housing and Covers
G3606 and G3608 Engines Hydraulic Tank (Hydrax) - Remove and Install
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Harness Code - Troubleshoot
G3500 Engines Carburetor - Disassemble - High Pressure
G3606 and G3608 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - High Pressure
G3500 Engines Carburetor - Remove - Low Pressure
3524B Engine for Caterpillar Built Machines Crankcase Breather - Remove and Install
3500B Engines and 3500 Engines with EUI Option Emergency Stop Switch
3034 Engine for Caterpillar Built Machines Turbocharger - Install
G3500 Engines Carburetor - Assemble - High Pressure
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Gear Group (Front)
G3500 Engines Electronic Sensor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 331 FMI 2 Switch (Engine Control) Incorrect Signal - Test
G3500 Engines Fuel Control Actuator - Remove and Install
3500B Engines and 3500 Engines with EUI Option Engine Control Switch (ECS)
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 3 Alarm Module Control Voltage Above Normal - Test
G3500 Engines Fuel Control Valve - Remove and Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 4 Alarm Module Control Voltage Below Normal - Test
G3500 Engines Gas Pressure Regulator Solenoid - Remove and Install