Gas Pressure Regulator - Install - High Pressure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install gas pressure regulator (4) and bolts (3).
- Connect tube assembly (1) to the fitting on gas pressure regulator (4).
- Install clamps (2) on the joint.
Show/hide table
Illustration 1 | g01280862 |
End By:
- Install the gas pressure regulator solenoid. Refer to Disassembly and Assembly, "Gas Pressure Regulator Solenoid - Remove and Install".
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 336 FMI 2 Switch (Engine Control) Incorrect Signal - Test
345B Excavator and 345B Material Handler Machine System Specifications Solenoid Valve (Counterweight Control)
G3500 Engines Gas Pressure Regulator - Remove - High Pressure
G3500 Engines Gas Pressure Regulator - Install - Low Pressure
G3500 Engines Gas Pressure Regulator - Remove - Low Pressure
3500B Engines Air Starting Motor - Disassemble
3500B Engines Air Starting Motor - Install
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Cylinder Head - Install
G3606 and G3608 Engines Actuator (Hydrax) - Remove
G3500 Engines Gas Pressure Regulator Solenoid - Remove and Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 4 Alarm Module Control Voltage Below Normal - Test
G3500 Engines Fuel Control Valve - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 441 FMI 12 Oil Step Relay Failed - Test
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Install - 3003 Engine
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove - 3003 Engines
3126B Marine Engine Alternator and Regulator
G3500 Engines Gas Pressure Regulator - Disassemble
3126B Marine Engine Alternator and Regulator
G3500 Engines Gas Pressure Regulator - Assemble
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Balancer Group - 3114 Engine Only
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 444 FMI 12 Starting Motor Relay Failed - Test
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 445 FMI 12 Run Relay Failed - Test
G3500 Engines Fuel Control Valve - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test