Carburetor - Assemble - High Pressure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the gaskets and the O-ring seals. Replace the gaskets and the O-ring seals, if necessary.
Show/hide table
Illustration 1 g00597405 Typical example - Install shaft (13), diaphragm (14), plate (15), and the screws in air valve assembly (12).
- Install O-ring seal (11) in air valve assembly (12).
- Install air valve assembly (12) and spring (16) in mixer housing (3).
- Install cover (17) and screws (18) on mixer housing (3).
- Install piston (9) and the screws in mixer housing (3).
- Install O-ring seal (8).
- Install valve (7) and the screw in mixer housing (3).
- Install O-ring seal (4), jet (5), and washer (6) in throttle assembly (2).
- Assemble mixer housing (3) and throttle assembly (2).
Show/hide table
Illustration 2 g00597403 Typical example - Install the gasket and adapter (1) on throttle assembly (2).
End By:
- Install the carburetor.
Caterpillar Information System:
3034 Engine for Caterpillar Built Machines Turbocharger - Install
3500B Engines and 3500 Engines with EUI Option Emergency Stop Switch
G3500 Engines Carburetor - Disassemble - High Pressure
G3500 Engines Carburetor - Assemble - High Pressure
3500B Engines Air Starting Motor - Remove
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Front Housing and Covers
G3606 and G3608 Engines Hydraulic Tank (Hydrax) - Remove and Install
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Harness Code - Troubleshoot
G3500 Engines Carburetor - Disassemble - High Pressure
G3606 and G3608 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - Low Pressure
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Gear Group (Front)
G3500 Engines Electronic Sensor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 331 FMI 2 Switch (Engine Control) Incorrect Signal - Test
G3500 Engines Fuel Control Actuator - Remove and Install
3500B Engines and 3500 Engines with EUI Option Engine Control Switch (ECS)
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 3 Alarm Module Control Voltage Above Normal - Test
G3500 Engines Fuel Control Valve - Remove and Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 333 FMI 4 Alarm Module Control Voltage Below Normal - Test
G3500 Engines Gas Pressure Regulator Solenoid - Remove and Install
G3606 and G3608 Engines Actuator (Hydrax) - Remove
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Cylinder Head - Install
3500B Engines Air Starting Motor - Install