Precombustion Chambers
Usage:
Remove Precombustion Chambers
preparatory step:
a) remove fuel injection valves
1. Drain the cooling system.
2. Remove the plug (or glow plug if so equipped) from precombustion chamber.
3. Using wrench (A), remove the precombustion chamber (1). Remove precombustion chamber gasket.
Install Precombustion Chambers
1. Coat the precombustion chamber threads with 9M3710 Anti-Seize Compound.
2. Position the gasket on precombustion chamber, and install chamber in cylinder head.
3. Using wrench (A), tighten the chamber to 150±5 lb. ft. (20,75±0,7 mkg).
4. Install glow plug in precombustion chamber and tighten to 120±24 lb. in. (138±27,67 cm.kg).
5. Fill the cooling system.
concluding step:
a) install fuel injection valves
Caterpillar Information System:
D346 INDUSTRIAL ENGINE Fuel Injection Valves
D346 INDUSTRIAL ENGINE Valve Covers
D346 INDUSTRIAL ENGINE Aftercooler Cores
D346 INDUSTRIAL ENGINE Turbochargers
D346 INDUSTRIAL ENGINE Air Cleaner Housings
D346 INDUSTRIAL ENGINE Exhaust Manifolds
D346 INDUSTRIAL ENGINE Fuel Injection Pump Housing
D346 INDUSTRIAL ENGINE Variable Timing Unit
D346 INDUSTRIAL ENGINE Governor
D346 INDUSTRIAL ENGINE Fuel Ratio Control With Override
D346 INDUSTRIAL ENGINE Safety Shutoff Control
D346 INDUSTRIAL ENGINE Fuel Injection Lines
D346 INDUSTRIAL ENGINE Right Camshaft Housing
D346 INDUSTRIAL ENGINE Left Camshaft Housing
D346 INDUSTRIAL ENGINE Right Cylinder Head Assembly
D346 INDUSTRIAL ENGINE Left Cylinder Head Assembly
D346 INDUSTRIAL ENGINE Spacer Plates
D346 INDUSTRIAL ENGINE Pistons
D346 INDUSTRIAL ENGINE Cylinder Liners
D346 INDUSTRIAL ENGINE Water Pump
D346 INDUSTRIAL ENGINE Turbocharger Lubrication Valve
D346 INDUSTRIAL ENGINE Starter
D346 INDUSTRIAL ENGINE Flywheel
D346 INDUSTRIAL ENGINE Crankshaft Rear Seal Ring & Thrower