Fuel Injection Lines
Usage:
Remove Fuel Injection Lines
1. Disconnect the fuel injection lines from the camshaft housings.
2. Disconnect the fuel injection lines from the fuel injection pump housing.
3. Remove the fuel injection line hold-down clamps (1) and clips (2).
4. Remove the fuel injection lines.
NOTE: Rotate the No. 1 line clockwise while removing in order to clear aftercooler housing.
5. Install caps or plugs in all lines or openings.
Install Fuel Injection Lines
1. Remove the caps and plugs from lines and openings.
2. Install the fuel injection lines.
3. Connect lines to fuel injection pump housing and to camshaft housings and tighten the nuts on both ends of lines to 30±5 lb. ft. (4,1±0,7 mkg).
4. Install hold-down clamps and clips.
Caterpillar Information System:
D346 INDUSTRIAL ENGINE Fuel Transfer Pump
D346 INDUSTRIAL ENGINE Front Timing Gear Plate And Camshaft Drive Idler Gear
D346 INDUSTRIAL ENGINE Front Balancer And Idler Gear
D346 INDUSTRIAL ENGINE Front Timing Gear Cover
D346 INDUSTRIAL ENGINE Crankshaft Front Seal
D346 INDUSTRIAL ENGINE Vibration Damper And Hub
D346 INDUSTRIAL ENGINE Alternator
D346 INDUSTRIAL ENGINE Oil Filter Housing
D346 INDUSTRIAL ENGINE Fuel Filter Housing
D346 INDUSTRIAL ENGINE Water Temperature Regulators
D346 INDUSTRIAL ENGINE Fuel Priming Pump
D346 INDUSTRIAL ENGINE Piston Cooling Jets
D346 INDUSTRIAL ENGINE Safety Shutoff Control
D346 INDUSTRIAL ENGINE Fuel Ratio Control With Override
D346 INDUSTRIAL ENGINE Governor
D346 INDUSTRIAL ENGINE Variable Timing Unit
D346 INDUSTRIAL ENGINE Fuel Injection Pump Housing
D346 INDUSTRIAL ENGINE Exhaust Manifolds
D346 INDUSTRIAL ENGINE Air Cleaner Housings
D346 INDUSTRIAL ENGINE Turbochargers
D346 INDUSTRIAL ENGINE Aftercooler Cores
D346 INDUSTRIAL ENGINE Valve Covers
D346 INDUSTRIAL ENGINE Fuel Injection Valves
D346 INDUSTRIAL ENGINE Precombustion Chambers