Engine Oil Coolers - Disassemble
Start By:
- Remove the engine oil coolers.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) and (3). Remove oil cooler core assembly (2) and the O-ring seals.
Show/hide table
Illustration 2 g03777957 Show/hide tableIllustration 3 g03777963 Show/hide tableIllustration 4 g03777964 - Remove tube (4) and the O-ring seal. Remove elbow (5) and gasket (6). Remove bonnet (7) and gasket (8). Discard the gaskets.
- Repeat step 2 for the opposite end of oil cooler core assembly (2).
Show/hide table
Illustration 5 g03777968 - Remove manifolds (9) and the O-ring seals. Remove housing (10).
Show/hide table
Illustration 6 g03777997 Show/hide tableIllustration 7 g03777998 - Remove bonnet (11) and gaskets (12). Discard the gaskets.
Show/hide table
Illustration 8 g03778018 Show/hide tableIllustration 9 g03778019 - Remove bolts (13). Remove bonnet and elbow assembly (14) . Remove and discard gasket (15).
Show/hide table
Illustration 10 g03778020 Show/hide tableIllustration 11 g03778021 - Remove bolts (16) and remove manifold assembly (17). Remove and discard gasket (18).
Show/hide table
Illustration 12 g03778026 - Mark orientation of engine oil cooler cores (21) and brackets (19) for reassembly. Remove bolts (20) and brackets (19) and remove engine oil cooler cores (21).
Show/hide table
Illustration 1 | g03777942 |
Caterpillar Information System:
336F XE Excavator Production Measurement Application
2014/12/19 Replacing the Hazardous Location Customer Connection Harness on Certain C9 and C15 Commercial Engines {1403, 1408}
2014/12/24 Accurate Diagnosis of Turbocharger Failure on Certain G3500 Engines {1052}
C3.4B Engines ECM Software - Install
C13 Industrial Engine Temperature Sensor - Remove and Install - DPF Inlet, SCR Inlet
C4.4 and C6.6 Engines Oil Contains Fuel
C4.4 and C7.1 Engines Oil Contains Coolant
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Engine Oil Coolers - Remove and Install
C15 Generator Set Generator Set - Test
C15 Generator Set Generator Bearing Temperature - Test/Record
465-0680 Top End Overhaul Foundational Kit for 3516 Generator Set Engines{1000} 465-0680 Top End Overhaul Foundational Kit for 3516 Generator Set Engines{1000}
C3.4B Engines Service Tool Features
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Engine Oil Coolers - Assemble
Generators for C15/C18 Engines Voltage Regulators
C280 Marine and Petroleum Engines Turbocharger
C280 Marine Engines Camshaft
C280 Marine and Petroleum Engines Cylinder Block
C280 Marine Engines Cylinder Liner
C280 Marine and Petroleum Engines Fuel Injection Lines
C280 Marine Engines Connecting Rod
C280 Marine Engines Crankshaft Seals
C280 Marine Engines Cylinder Block
C280 Marine Engines Housing (Front)
C280 Marine Engines Piston and Rings