Usage:
Start By:
a. remove cylinder head and spacer plate
1. Use a magnet (1) to remove valve lifters (2). Put identification on lifters for installation purposes.
NOTE: The following steps are for the installation of the valve lifters.
2. Check the diameter of the valve lifter. The diameter of the valve lifter (new) must be 33.287 ± 0.013 mm (1.3105 ± .0005 in.). The bore in the block for new valve lifters must be 33.388 ± 0.025 mm (1.3145 ± .0010 in.). The maximum permissible clearance between the lifter and the bore for the valve lifter (worn) is 0.30 mm (.012 in.).
3. Put 5P960 Multipurpose Grease on the valve lifters and camshaft lobes. Install the valve lifters in original positions in the cylinder block.
End By:
a. install cylinder head and spacer plate