Water Directors
Usage:
Remove And Install Water Directors
Start By:
a. remove cylinder head and spacer plate
1. Remove old water directors (1) from the cylinder head.
NOTE: The following steps are for the installation of the water directors.
2. Clean the cylinder head.
3. Install new water directors in the cylinder head with the notch in the water director in alignment with the "V" mark on the cylinder head. Install the water director to a depth of 0.8 ± 0.6 mm (.031 ± .023 in.) below the surface of the cylinder head.
End By:
a. install cylinder head and spacer plate
Caterpillar Information System:
3306 VEHICULAR ENGINE Valve Seat Inserts
3306 VEHICULAR ENGINE Valve Guides
3306 VEHICULAR ENGINE Valves
3306 VEHICULAR ENGINE Valve Lifters
3306 VEHICULAR ENGINE Cylinder Head And Spacer Plate
3306 VEHICULAR ENGINE Rocker Shaft
3306 VEHICULAR ENGINE Rocker Shaft And Push Rods
3306 VEHICULAR ENGINE Valve Cover
3306 VEHICULAR ENGINE Aftercooler
3306 VEHICULAR ENGINE Turbocharger
3306 VEHICULAR ENGINE Turbocharger
3306 VEHICULAR ENGINE Exhaust Manifold
3306 VEHICULAR ENGINE Pistons
3306 VEHICULAR ENGINE Cylinder Liners
3306 VEHICULAR ENGINE Fan And Fan Drive
3306 VEHICULAR ENGINE Fan Drive
3306 VEHICULAR ENGINE Crankshaft Main Bearings
3306 VEHICULAR ENGINE Connecting Rod Bearings
3306 VEHICULAR ENGINE Air Compressor
3306 VEHICULAR ENGINE Air Compressor Governor
3306 VEHICULAR ENGINE Crankshaft Front Seal And Wear Sleeve
3306 VEHICULAR ENGINE Crankshaft Damper And Pulley
3306 VEHICULAR ENGINE Engine Front Support
3306 VEHICULAR ENGINE Timing Gear Cover