Mounting Bracket - Remove and Install
Removal Procedure
Start By:
- Remove the work tool from the host machine. Refer to Operations and Maintenance Manual, SEBU7391, "Work Tool Installation and Removal".
Show/hide table
Illustration 1 | g00729140 |
Typical Example |
When possible, position the work tool upright. The work tool should only be positioned in this manner on a solid, level surface. Refer to Illustration 1 for proper positioning of the work tool. If a solid level surface is not available, lay the work tool on a side.
- Attach an appropriate nylon lifting sling and a hoist to mounting bracket (1). The weight of the brackets are listed in Table 1.
- Remove the bolts and the washers from the mounting bracket. Lift the mounting bracket from the work tool.
Show/hide table
Part Number (Mounting Bracket)     | Weight of the Mounting Bracket     |
169-4976     | 313 kg (690 lb)     |
169-4978     | 399 kg (880 lb)     |
169-4980     | 339 kg (747 lb)     |
169-4981     | 400 kg (882 lb)     |
169-5307     | 525 kg (1157 lb)     |
188-7393     | 484 kg (1067 lb)     |
190-5435     | 365 kg (805 lb)     |
Installation Procedure
- Attach an appropriate nylon lifting sling and a hoist to mounting bracket (1). The weight of the brackets are listed in Table 1. Lift the mounting bracket into position on the work tool.
Show/hide table
Illustration 2 | g00729140 |
Typical Example |
- Install the bolts and the washers to the mounting bracket. Tighten the bolts to a torque of 1000 ± 125 N·m (738 ± 92 lb ft).
Caterpillar Information System:
MP-15, MP-20, MP-30 and MP-40 Multi Processors Control Valve Pressure (Hydraulic Rotator) - Test
3126B Engines Electrical System
320C Excavator Window Wiper and Washer Control
H140C S and H160C S Hydraulic Hammers Mounting Bracket Bolts - Tighten
320C Excavator Cab Door
325C and 325C L Excavator Alternate Exit
MP-15, MP-20, MP-30 and MP-40 Multi Processors Speed Control Valve (Hydraulic Cylinder) - Test and Adjust
330C Excavator Window (Front)
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
320C Excavator Seat Heater - If Equipped
320C Excavator Storage Box
320C Excavator Engine Speed Control
320C Excavator Automatic Engine Speed Control (AEC)
320C Excavator Fine Swing Control - If Equipped
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator Cycle Time - Check
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
3176C and 3196 Engines for Caterpillar Built Machines Intermittent Low Power or Power Cutout
3126B Engines Electronic Control System Components
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
MP-15, MP-20, MP-30 and MP-40 Multi Processors Shear Jaw
JF Series Starting Motor Pinion Continues to Engage after Engine Starts
MP-15, MP-20, MP-30 and MP-40 Multi Processors Multi-Processor Housing