Cab Door
Show/hide table
Illustration 1 | g00681088 |
Push the knob of the cab door latch forward in order to open the cab door. For additional ventilation, open the cab door all the way and secure the cab door to the catch on the wall of the cab.
Side Window
Show/hide table
Illustration 2 | g00681084 |
Release the latch and slide the side window to the desired position in order to open the side window. To close the side window, reverse the procedure that is used for opening the side window.
Access Door Latches
Show/hide table
Illustration 3 | g00735894 |
Show/hide table
Illustration 4 | g00107589 |
The following procedure can be used to open the left access door or the right access door.
- Pull the door latch until the latch is perpendicular to the machine.
- Rotate the door latch clockwise by 1/4 turn or rotate the door latch counterclockwise by 1/4 turn.
- Pull the access door open.
- To close the access door, repeat the steps in reverse order.
Caterpillar Information System:
325C and 325C L Excavator Alternate Exit
MP-15, MP-20, MP-30 and MP-40 Multi Processors Speed Control Valve (Hydraulic Cylinder) - Test and Adjust
330C Excavator Window (Front)
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
320C Excavator Seat Heater - If Equipped
320C Excavator Storage Box
3176C and 3196 Engines for Caterpillar Built Machines Engine Cranks but Will Not Start
325D and 329D Excavators Radio - If Equipped
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
307C Excavator Hydraulic System Main Pump (Flow) - Test
JF Series Starting Motor Starting Motor Solenoid - Test
H140C S and H160C S Hydraulic Hammers Mounting Bracket Bolts - Tighten
320C Excavator Window Wiper and Washer Control
3126B Engines Electrical System
MP-15, MP-20, MP-30 and MP-40 Multi Processors Control Valve Pressure (Hydraulic Rotator) - Test
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
320C Excavator Engine Speed Control
320C Excavator Automatic Engine Speed Control (AEC)
320C Excavator Fine Swing Control - If Equipped
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator Cycle Time - Check
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket
3176C and 3196 Engines for Caterpillar Built Machines Intermittent Low Power or Power Cutout
3126B Engines Electronic Control System Components