Seat Heater - If Equipped
Show/hide table
Preexisting skin conditions can be aggravated by continued use of the seat heater. If skin condition worsens, discontinue use of the seat heater. |
Show/hide table
Illustration 1 | g00729164 |
The seat heater switch is located on the right side instrument panel.
Show/hide table
Seat Heater - In cold weather, the seat heater can be activated in order to improve operator comfort. |
Show/hide table
ON - Push down on the top of the seat heater switch in order to activate the seat heater. |
Show/hide table
OFF - Push down on the bottom of the seat heater switch in order to deactivate the seat heater. |
Show/hide table
NOTICE |
---|
Do not leave any heavy item or object with a sharp point on the seat. Do not cover the seat or seat back with a blank, seat cushion or any other similar covering. The seat heater can be over heated. Be sure to remove any spills on the seat and thoroughly dry the spill. |
Note: The thermostat in the seat heater deactivates when the temperature in the cab is above 10°C (50°F). The seat heater will not operate when the thermostat is deactivated.
Caterpillar Information System:
320C Excavator Storage Box
3176C and 3196 Engines for Caterpillar Built Machines Engine Cranks but Will Not Start
325D and 329D Excavators Radio - If Equipped
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
307C Excavator Hydraulic System Main Pump (Flow) - Test
JF Series Starting Motor Starting Motor Solenoid - Test
2000/10/30 Part Numbers for Electric Motors That Are Used in HVAC Have Changed {5927}
M318 Excavator Hydraulic System Relief Valve (Line) - Test and Adjust - Travel Motor
JF Series Starting Motor Starting Motor Continues to Operate after Start Switch Has Been Released
JF Series Starting Motor Pinion Does Not Engage Ring Gear While Armature Turns
307C Excavator Hydraulic System Relief Valve (Swing) - Test and Adjust
2000/08/07 The Assembly Procedure for the Main Hydraulic Pump Is Changed {5070}
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
330C Excavator Window (Front)
MP-15, MP-20, MP-30 and MP-40 Multi Processors Speed Control Valve (Hydraulic Cylinder) - Test and Adjust
325C and 325C L Excavator Alternate Exit
320C Excavator Cab Door
H140C S and H160C S Hydraulic Hammers Mounting Bracket Bolts - Tighten
320C Excavator Window Wiper and Washer Control
3126B Engines Electrical System
MP-15, MP-20, MP-30 and MP-40 Multi Processors Control Valve Pressure (Hydraulic Rotator) - Test
G112, G115, G125 and G140 Mechanical Grapple Mounting Bracket - Remove and Install
320C Excavator Engine Speed Control