Magneto
Usage:
Remove Magneto
1. Put an identification mark on each wire and screw.
2. Remove the wires (1) from the magneto (3).
3. Remove the magneto mounting bolts (2).
4. Remove the magneto (3).
Install Magneto
1. Put the magneto in time with the engine. See TIMING MAGNETO TO ENGINE in TESTING AND ADJUSTING.
2. Install magneto (2) and fastening bolts.
3. Install the wires (1) on the magneto. Each wire must be put back on the same terminal that it was removed from.
Caterpillar Information System:
SCSA SOLID STATE MAGNETO Pulser Coil Installation
SCSA SOLID STATE MAGNETO Storage Capacitor Installation
SCSA SOLID STATE MAGNETO Zener Diode Installation
SCSA SOLID STATE MAGNETO Power Board Installation
SCSA SOLID STATE MAGNETO Power Resistor Installation
SCSA SOLID STATE MAGNETO Distribution Board Installation (6 and 8 Cylinder Magnetos)
SCSA SOLID STATE MAGNETO Distribution Board Installation (12 Cylinder Magneto)
SCSA SOLID STATE MAGNETO Mechanical Drive Disassembly
SCSA SOLID STATE MAGNETO Generator Coil Installation
SCSA SOLID STATE MAGNETO Failure Analysis
SCSA SOLID STATE MAGNETO Typical Ignition Cycle Per Cylinder
SCSA SOLID STATE MAGNETO Introduction
G333C ENGINE Governor And Governor Drive
G333C ENGINE Governor
G333C ENGINE Governor Drive
G333C ENGINE Oil Cooler And Filter Base
G333C ENGINE Auxiliary Water Pump
G333C ENGINE Auxiliary Water Pump Drive
G333C ENGINE Engine Water Pump
G333C ENGINE Oil Pan
G333C ENGINE Oil Pump
G333C ENGINE Oil Pan Plate
G333C ENGINE Connecting Rod Bearings
G333C ENGINE Crankshaft Main Bearings