563D and 573D Wheel Feller Buncher Caterpillar


Windows - Clean

Usage:

563D D63


Illustration 1g02662523


NOTICE

When performing maintenance above ground level, always use appropriate devices such as extendable handles, ladders and man lift machines.


The use of self propelled cleaning agents are prohibited and should not be used to clean the windows based on the highly reactive chemical composition that will damage the windows. However, the use of Ammonia Free Windex is an approved product.

General Cleaning


NOTICE

Wash polycarbonate windows with mild soap and water. Never use a cleaning solvent on polycarbonate windows. Never wipe dust in a dry state, as polycarbonate windows can be easily scratched.


  1. Thoroughly pre-rinse with warm water to loosen and wash away surface material, grit, and grime.

  2. Using a soft microfiber cloth or moist non-abrasive sponge, gently wash with a mild diluted soap or detergent.

  3. Rinse thoroughly with lukewarm clean water. To prevent water spots, thoroughly dry the glazing with a dry soft cloth.

Removing Heavy Oils and Tars

  1. Thoroughly pre-rinse with warm water to loosen and wash away surface material, grit, and grime.

  2. With a 50/50 isopropyl alcohol-water mixture, gently rub the area with a soft non-abrasive cloth.

  3. Immediately rinse thoroughly with lukewarm clean water. To prevent water spots, thoroughly dry the glazing with a dry soft cloth.

Points to Remember

  1. Do not use abrasive cleaners.

  2. Do not use high alkaline cleaners (high pH or ammoniated cleaners).

  3. Do not leave cleaners sitting on polycarbonate for periods of time. Wash off immediately with warm clean water.

  4. Do not apply cleaners under direct sunlight or at elevated temperatures.

  5. Do not clean your polycarbonate with any unapproved cleaners. When in doubt, seek guidance. Using scrapers, squeegees, razors or other sharp instruments may permanently scratch your polycarbonate.

  6. Do Not Buff the surface. Always avoid dry rubbing/cleaning your polycarbonate, as sand and dust particles clinging to the exterior of the glazing may scratch the surface. An Anti-Static Canned-Air Ionizer can reduce electrostatic charge buildup on polycarbonate, therefore reducing dirt and dust buildup that would hinder cleaning.

Note: The edges of your polycarbonate windows are not protected by a specialized hard coating. Do not allow cleaning solutions, solvents, or chemicals to come in contact, or pool, along the edges of the windows. Rinse the edges thoroughly with generous amounts of lukewarm clean water.

Caterpillar Information System:

Product Link ® Elite PLE742 Systems Service Tools
Oil Fill Capacity for the Circle Drive Housing has been Updated on Certain 14M Series 3 Motor Graders {0374, 5207} Oil Fill Capacity for the Circle Drive Housing has been Updated on Certain 14M Series 3 Motor Graders {0374, 5207}
A New Thermowell Is Available for Certain C175 Off-Highway Truck/Tractor Engines {7498} A New Thermowell Is Available for Certain C175 Off-Highway Truck/Tractor Engines {7498}
MP318, MP324, MP332, MP345 and and MP365 Multi-Processors and Jaws Control Manifold
New C175 High Altitude Low Maintenance Ratio Engine for 797 Off-Highway Trucks {1000} New C175 High Altitude Low Maintenance Ratio Engine for 797 Off-Highway Trucks {1000}
Troubleshooting Procedures for Supercom Data Acquisition Systems are Now Available for Certain Off-Highway Trucks {7600, 7601, 7606, 7620} Troubleshooting Procedures for Supercom Data Acquisition Systems are Now Available for Certain Off-Highway Trucks {7600, 7601, 7606, 7620}
The Buffer Seal Assembly in the Steering Cylinder Group May Wear Prematurely on Certain 773G, 775G, and 777G Off-Highway Trucks {4303, 7555} The Buffer Seal Assembly in the Steering Cylinder Group May Wear Prematurely on Certain 773G, 775G, and 777G Off-Highway Trucks {4303, 7555}
Shims Added to Coupler to Decrease Side to Side Motion Are Now Used on Certain Compact Track Loaders, Multi Terrain Loaders, and Skid Steer Loaders {6129, 7000} Shims Added to Coupler to Decrease Side to Side Motion Are Now Used on Certain Compact Track Loaders, Multi Terrain Loaders, and Skid Steer Loaders {6129, 7000}
C175 Tier 4 Final Engines for Caterpillar Built Machines Air Inlet Manifold - Remove and Install
3516E Engines for Caterpillar Built Machines Fuel Priming Pump - Remove and Install - With Fuel/Water Separator
2570C and 2670C Wheel Feller Bunchers Cab Tilting
C7 Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump
3516E Engines for Caterpillar Built Machines Vibration Damper - Remove and Install
3512C Engines for 785C Off-Highway Trucks with Dynamic Gas Blending Intake Manifold Air Temperature Is High
CB64B, CB66B and CB68B Asphalt Compactors Machine Electronic Control System Machine Steer not Responding Properly
AP655F and AP655F L Asphalt Paver Declaration of Conformity
Improved Engine Software and Diesel Exhaust Fluid Injector Assembly Is Now Used on Certain Material Handlers, Mobile Hydraulic Power Units, and Wheeled Excavators {108I, 7610, 7620} Improved Engine Software and Diesel Exhaust Fluid Injector Assembly Is Now Used on Certain Material Handlers, Mobile Hydraulic Power Units, and Wheeled Excavators {108I, 7610, 7620}
New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202} New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202}
New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202} New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202}
The Pressure Setting on the Hoist Raise Valve Group May Be Low on Certain Off-Highway Trucks {5051, 5069, 5117} The Pressure Setting on the Hoist Raise Valve Group May Be Low on Certain Off-Highway Trucks {5051, 5069, 5117}
The Housing Assembly for the Front Suspension Group May Crack on Certain 773G and 775G Off-Highway Trucks {7200, 7201} The Housing Assembly for the Front Suspension Group May Crack on Certain 773G and 775G Off-Highway Trucks {7200, 7201}
An Improved Rear Wheel Bearing for Certain Large Off-Highway Trucks is Available {4008, 7551} An Improved Rear Wheel Bearing for Certain Large Off-Highway Trucks is Available {4008, 7551}
Improved Product Link On-Board Software is Now Available for All Cat® Products {7606} Improved Product Link On-Board Software is Now Available for All Cat® Products {7606}
New Procedure for Power Cycle is Now Available for Certain Cat® Product Link (PL131) Devices {7606} New Procedure for Power Cycle is Now Available for Certain Cat® Product Link (PL131) Devices {7606}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.