The Housing Assembly for the Front Suspension Group May Crack on Certain 773G and 775G Off-Highway Trucks {7200, 7201}
- Quarry Truck
- 773G (S/N: MWH1-UP; JWS427-UP; T5S126-UP; T5T1-UP)
- 775G (S/N: T5F103-UP; RFM1-UP; MJS651-UP; T5W1-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
Show/hide table
Illustration 1 | g06311830 |
Location of cracks on the housing assembly - front suspension group |
Show/hide table
Illustration 2 | g06311833 |
(A) |
Housing assembly (A) may crack on the front suspension groups of the machines listed above. Housing assembly (A) failure results in Nitrogen/hydraulic leakage seen primarily as a slight oil leak that originates on the portion of housing assembly (A) just above the mounting flange as shown in Illustration 1.
Solution
Caterpillar is aware of this problem and is recommending the following interim corrective action.
If cracks occur on housing assembly (A), replace with the same part.
Note: Do not attempt to repair cracks by welding.
Caterpillar Information System:
The Pressure Setting on the Hoist Raise Valve Group May Be Low on Certain Off-Highway Trucks {5051, 5069, 5117} The Pressure Setting on the Hoist Raise Valve Group May Be Low on Certain Off-Highway Trucks {5051, 5069, 5117}
New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202} New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202}
New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202} New Preservation Process for Crankshafts is Now Used for 3500, G3500, and C175-16 Series Engines {1202}
Improved Engine Software and Diesel Exhaust Fluid Injector Assembly Is Now Used on Certain Material Handlers, Mobile Hydraulic Power Units, and Wheeled Excavators {108I, 7610, 7620} Improved Engine Software and Diesel Exhaust Fluid Injector Assembly Is Now Used on Certain Material Handlers, Mobile Hydraulic Power Units, and Wheeled Excavators {108I, 7610, 7620}
AP655F and AP655F L Asphalt Paver Declaration of Conformity
CB64B, CB66B and CB68B Asphalt Compactors Machine Electronic Control System Machine Steer not Responding Properly
3512C Engines for 785C Off-Highway Trucks with Dynamic Gas Blending Intake Manifold Air Temperature Is High
3516E Engines for Caterpillar Built Machines Vibration Damper - Remove and Install
563D and 573D Wheel Feller Buncher Windows - Clean
Product Link ® Elite PLE742 Systems Service Tools
Oil Fill Capacity for the Circle Drive Housing has been Updated on Certain 14M Series 3 Motor Graders {0374, 5207} Oil Fill Capacity for the Circle Drive Housing has been Updated on Certain 14M Series 3 Motor Graders {0374, 5207}
A New Thermowell Is Available for Certain C175 Off-Highway Truck/Tractor Engines {7498} A New Thermowell Is Available for Certain C175 Off-Highway Truck/Tractor Engines {7498}
An Improved Rear Wheel Bearing for Certain Large Off-Highway Trucks is Available {4008, 7551} An Improved Rear Wheel Bearing for Certain Large Off-Highway Trucks is Available {4008, 7551}
Improved Product Link On-Board Software is Now Available for All Cat® Products {7606} Improved Product Link On-Board Software is Now Available for All Cat® Products {7606}
New Procedure for Power Cycle is Now Available for Certain Cat® Product Link (PL131) Devices {7606} New Procedure for Power Cycle is Now Available for Certain Cat® Product Link (PL131) Devices {7606}
MP318, MP324, MP332, MP345 and and MP365 Multi-Processors and Jaws Multi-Processor Hydraulic System
MP318, MP324, MP332, MP345 and and MP365 Multi-Processors and Jaws Hydraulic Cylinder
MP318, MP324, MP332, MP345 and and MP365 Multi-Processors and Jaws Hydraulic Cylinder
PM820, PM822, and PM825 Cold Planer Fuel System Secondary Filter - Replace
PM820, PM822, and PM825 Cold Planer Fuel System Primary Filter (Water Separator) Element - Replace
New Software Updates are Now Available for Certain 773E and 777E Off-Highway Trucks {7490, 7610, 7620} New Software Updates are Now Available for Certain 773E and 777E Off-Highway Trucks {7490, 7610, 7620}
An Improved Stub Shaft is now Used for the CX38 Transmission in Certain 700 Series Articulated Trucks {3063, 3160} An Improved Stub Shaft is now Used for the CX38 Transmission in Certain 700 Series Articulated Trucks {3063, 3160}
966M XE and 972M XE Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Hydraulic Oil Cooler - Lines
PM820, PM822, and PM825 Cold Planer Air Pressure Regulator