Valve Covers
Usage:
Remove Valve Covers
1. Loosen the crankcase breather pipe hose clamp (left valve cover only).
2. Remove the valve cover mounting bolts. Remove the valve cover.
Install Valve Covers
1. Install a new valve cover seal if necessary.
NOTE: When installing new seal, cut the seal to provide a minimum of 1 in. (2,5 cm) overlap.
2. Position the valve cover on engine and install mounting bolts.
3. Tighten the crankcase breather pipe hose clamp.
Caterpillar Information System:
DISASSEMBLY AND ASSEMBLY D346 Aftercooler Cores
DISASSEMBLY AND ASSEMBLY D346 Turbochargers
DISASSEMBLY AND ASSEMBLY D346 Exhaust Manifolds
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Pump Housing
DISASSEMBLY AND ASSEMBLY D346 Variable Timing Unit
DISASSEMBLY AND ASSEMBLY D346 Governor
DISASSEMBLY AND ASSEMBLY D346 Fuel Ratio Control
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Lines
DISASSEMBLY AND ASSEMBLY D346 Fuel Filter Housing
DISASSEMBLY AND ASSEMBLY D346 Fuel Filter Elements
DISASSEMBLY AND ASSEMBLY D346 Fuel Transfer Pump
DISASSEMBLY AND ASSEMBLY D346 Fuel Priming Pump
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Valves
DISASSEMBLY AND ASSEMBLY D346 Glow Plugs
DISASSEMBLY AND ASSEMBLY D346 Precombustion Chambers
DISASSEMBLY AND ASSEMBLY D346 Camshaft Housings
DISASSEMBLY AND ASSEMBLY D346 Cylinder Head Assembly
DISASSEMBLY AND ASSEMBLY D346 Spacer Plates
DISASSEMBLY AND ASSEMBLY D346 Pistons
DISASSEMBLY AND ASSEMBLY D346 Cylinder Liners
DISASSEMBLY AND ASSEMBLY D346 Air Compressor
DISASSEMBLY AND ASSEMBLY D346 Flywheel
DISASSEMBLY AND ASSEMBLY D346 Crankshaft Rear Seal Ring & Thrower
DISASSEMBLY AND ASSEMBLY D346 Flywheel Housing