Fuel Injection Valves
Usage:
Remove Fuel Injection Valves
preparatory step:
a) remove valve covers
1. Remove the inner fuel injection line (1).
2. Remove fuel injection valve retaining nut (2).
3. Remove the fuel injection valve assembly from precombustion chamber. Remove the valve from body.
Install Fuel Injection Valves
1. Install the fuel injection valve finger tight on the body. Install the valve assembly in precombustion chamber.
2. Install the valve retaining nut (2) and tighten to an initial torque of 85 ± 5 lb. ft. (11,8 ± 0,7 mkg). Hand tighten retaining nut to a final torque of 105 ± 5 lb. ft. (14,5 ± 0,7 mkg).
3. Install the inner fuel injection line. Tighten retaining nuts to 30 ± 5 lb. ft. (4,1 ± 0,7 mkg).
concluding step:
a) install valve covers
Caterpillar Information System:
DISASSEMBLY AND ASSEMBLY D346 Valve Covers
DISASSEMBLY AND ASSEMBLY D346 Aftercooler Cores
DISASSEMBLY AND ASSEMBLY D346 Turbochargers
DISASSEMBLY AND ASSEMBLY D346 Exhaust Manifolds
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Pump Housing
DISASSEMBLY AND ASSEMBLY D346 Variable Timing Unit
DISASSEMBLY AND ASSEMBLY D346 Governor
DISASSEMBLY AND ASSEMBLY D346 Fuel Ratio Control
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Lines
DISASSEMBLY AND ASSEMBLY D346 Fuel Filter Housing
DISASSEMBLY AND ASSEMBLY D346 Fuel Filter Elements
DISASSEMBLY AND ASSEMBLY D346 Fuel Transfer Pump
DISASSEMBLY AND ASSEMBLY D346 Glow Plugs
DISASSEMBLY AND ASSEMBLY D346 Precombustion Chambers
DISASSEMBLY AND ASSEMBLY D346 Camshaft Housings
DISASSEMBLY AND ASSEMBLY D346 Cylinder Head Assembly
DISASSEMBLY AND ASSEMBLY D346 Spacer Plates
DISASSEMBLY AND ASSEMBLY D346 Pistons
DISASSEMBLY AND ASSEMBLY D346 Cylinder Liners
DISASSEMBLY AND ASSEMBLY D346 Air Compressor
DISASSEMBLY AND ASSEMBLY D346 Flywheel
DISASSEMBLY AND ASSEMBLY D346 Crankshaft Rear Seal Ring & Thrower
DISASSEMBLY AND ASSEMBLY D346 Flywheel Housing
DISASSEMBLY AND ASSEMBLY D346 Rear Timing Gears And Plate