Usage:
1. Drain the cooling system.
2. Disconnect equalizer line (1) from aftercooler air inlet line.
3. Disconnect governor control linkage from the governor. Remove the governor control channel assembly.
4. Remove aftercooler air inlet line retaining clamp and bolt from turbocharger housing.
5. Remove aftercooler vent lines from front of aftercooler housing.
6. Remove fuel filter housing (2) and mounting brackets. Remove fuel transfer pump inlet and outlet lines. Remove fuel filter housing and injection pump housing bleed lines. Remove fuel line to injection pump housing. Remove primary fuel filter (right side only).
7. Remove the four cover assembly mounting bolts. Pull the cover assembly (3) out of the housing.
8. Remove the aftercooler upper housing mounting bolts. Remove the aftercooler upper housing.
9. Remove the aftercooler water outlet elbow (4). Pull the sleeve assembly (5) out of aftercooler core.
10. Remove the aftercooler water inlet elbow mounting bolts from rear of aftercooler lower housing. Rotate the elbow (6) away from housing. Pull the sleeve assembly (7) out of aftercooler core.
11. Remove the aftercooler core-weight 40 lbs. (18 kg).
Install Aftercooler Cores
1. Thoroughly clean old gaskets from mating surfaces of aftercooler core and upper and lower housings.
2. Install a new core-to-lower housing gasket. Install the aftercooler core into lower housing.
3. Install the sleeve assemblies in front and rear of aftercooler lower housing.
| NOTICE |
|---|
Be sure that drain hole in sleeve assemblies is in downward position. |
4. Position the water inlet elbow to rear of aftercooler housing and install mounting bolts.
5. Install the water outlet elbow on front of aftercooler housing.
6. Install a new core-to-upper housing gasket. Install the aftercooler upper housing and mounting bolts.
7. Install aftercooler air inlet line retaining clamp and bolt in turbocharger housing.
8. Install the cover assembly in front of aftercooler housing. Install cover assembly mounting bolts.
9. Install fuel filter housing and mounting brackets. Install fuel transfer pump inlet and outlet lines. Install bleed lines and fuel line to injection pump housing. Install primary fuel filter (right side only).
10. Connect equalizer pipe to aftercooler air inlet line.
11. Install the aftercooler vent line.
12. Install the governor control channel assembly. Connect governor control linkage to governor.
13. Fill the cooling system.