Precombustion Chambers
Usage:
Install Precombustion Chambers
1. Coat the precombustion chamber threads with 9M3710 Anti-Seize Compound.
2. Position the gasket (1) on precombustion chamber. Install the precombustion chamber in cylinder head.
3. Using wrench (A), tighten the precombustion chamber to 150 ± 5 lb. ft. (20,8 ± 0,7 mkg).
4. Fill the cooling system.
concluding steps:
a) install glow plugs
b) install fuel injection valves
Caterpillar Information System:
DISASSEMBLY AND ASSEMBLY D346 Glow Plugs
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Valves
DISASSEMBLY AND ASSEMBLY D346 Valve Covers
DISASSEMBLY AND ASSEMBLY D346 Aftercooler Cores
DISASSEMBLY AND ASSEMBLY D346 Turbochargers
DISASSEMBLY AND ASSEMBLY D346 Exhaust Manifolds
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Pump Housing
DISASSEMBLY AND ASSEMBLY D346 Variable Timing Unit
DISASSEMBLY AND ASSEMBLY D346 Governor
DISASSEMBLY AND ASSEMBLY D346 Fuel Ratio Control
DISASSEMBLY AND ASSEMBLY D346 Fuel Injection Lines
DISASSEMBLY AND ASSEMBLY D346 Fuel Filter Housing
DISASSEMBLY AND ASSEMBLY D346 Camshaft Housings
DISASSEMBLY AND ASSEMBLY D346 Cylinder Head Assembly
DISASSEMBLY AND ASSEMBLY D346 Spacer Plates
DISASSEMBLY AND ASSEMBLY D346 Pistons
DISASSEMBLY AND ASSEMBLY D346 Cylinder Liners
DISASSEMBLY AND ASSEMBLY D346 Air Compressor
DISASSEMBLY AND ASSEMBLY D346 Flywheel
DISASSEMBLY AND ASSEMBLY D346 Crankshaft Rear Seal Ring & Thrower
DISASSEMBLY AND ASSEMBLY D346 Flywheel Housing
DISASSEMBLY AND ASSEMBLY D346 Rear Timing Gears And Plate
DISASSEMBLY AND ASSEMBLY D346 Crankshaft
D343 INDUSTRIAL & MARINE ENGINES Fuel Priming Pump