Usage:
preparatory steps:
a) remove crankshaft rear seal ring and thrower
b) remove water pump
c) remove starter
d) remove oil pan base
1. Remove the turbocharger lubrication valve oil inlet line (1). Remove the turbocharger lubrication lines (2) as a unit.
2. Remove the left and right turbocharger oil drain lines.
3. Remove the right air cleaner support bracket-to-flywheel housing mounting bolts and spacers.
4. Remove the flywheel housing mounting bolts and nuts.
5. Attach a hoist and lifting bracket (A), and remove the flywheel housing - weight 390 lbs. (177 kg).
Install Flywheel Housing
1. Install a new flywheel housing-to-timing gear plate gasket. Trim the gasket flush with pan face of cylinder block.
2. Attach a hoist and lifting bracket (A) to the flywheel housing. Position the housing on engine making sure that gear on flywheel housing is engaged with oil pump idler gear and crankshaft gear. Install the housing mounting bolts and nuts.
3. Install the right air cleaner support bracket mounting bolts and spacers.
4. Install the turbocharger oil drain lines. Install the turbocharger lubrication lines and valve oil inlet line.
concluding steps:
a) install crankshaft rear seal ring and thrower
b) install water pump
c) install starter
d) install oil pan base