Usage:
1. Use tooling (A) to install the seals in the regulator housing with the lip in as shown.
2. Put the gasket and regulator housing (1) in position on the engine and install the four bolts that hold them in place.
3. Install the gasket and elbow (2) on the left end of the regulator housing.
4. Connect vent line (3) to the elbow.
5. Install the gasket and elbow (4) on the right end of the regulator housing.
6. Install water temperature regulators (5) in the regulator housing as shown.
7. Install the gasket and cover (6) on the regulator housing.
8. Install the gaskets and elbows (7) on both sides of the expansion tank.
9. Install tubes (8) and adapters (9) as a unit with gaskets on the aftercoolers.
10. Install brace (10).
11. Fill the jacket water cooling system.