Coolant Temperature Sender - Remove and Install
Note: The coolant temperature sensor is located in the water temperature regulator housing.
- Drain the coolant from the cooling system to a level below the coolant temperature sensor into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - change" for the correct draining and refilling procedures.
Show/hide table
Illustration 1 g03392900 - Disconnect harness assembly (1) and remove coolant temperature sensor (2).
- Remove the O-ring seal from the coolant temperature sensor.
- Install coolant temperature sensor (2) in the reverse order of removal.
- Tighten coolant temperature sensor (2) to a torque of
20 ± 3 N·m (177 ± 27 lb in) .
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
- Tighten coolant temperature sensor (2) to a torque of
Caterpillar Information System:
C18 Generator Set Engines Crankshaft Position Sensor - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Plate Locations and Film Locations
A New Turbocharger Is Now Used On Certain 3516C Engines {1052, 1053} A New Turbocharger Is Now Used On Certain 3516C Engines {1052, 1053}
G3512 Generator Set Product Description
Bench Test Procedure For A TA22 Construction Transmission {0374, 0599, 3030, 3065, 3139, 3167, 3182} Bench Test Procedure For A TA22 Construction Transmission {0374, 0599, 3030, 3065, 3139, 3167, 3182}
XQP150 Rental Generator Set Generator Lead Connections
C175 Tier 4 Final Engines for Off-Highway Trucks Coolant Pressure Is Low
C18 Generator Set Engines Camshaft Position Sensor - Remove and Install
C12.9 Marine Engines Aftercooler - Remove and Install - High-Pressure
XQP150 Rental Generator Set Control Panel
3512E Engines Housing (Front) - Remove and Install
C7.1 Industrial Engine Flywheel Housing - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Emissions Certification Film
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Reference Information
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Product Lifting
XQP150 Rental Generator Set Setup
C18 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Alarms and Shutoffs
G3512 Generator Set Engines Sensor Signal (Analog, Active) - Test
C18 Generator Set Engines Crankcase Pressure Sensor - Remove and Install
C18 Generator Set Engines Fuel Pressure Sensor - Remove and Install
323F SA and 323F LN Excavator and 323F LN MHPU Machine Systems Specifications Check Valve
G3512 Generator Set Before Starting Engine
G3512 Generator Set Cold Weather Starting