Check Valve
Show/hide table
Illustration 1 | g06053433 |
Show/hide table
Specification for 335-0207 Check Valve Gp | |||
---|---|---|---|
Item | Qty | Part | Specification Description |
1 | 1 | 259-7514 Valve Plug | Before assembly, apply red Loctite 263 to the threads. |
Torque to |
|||
2 | 1 | 259-7513 Check Valve Spring | Length under test force is |
Test force is |
|||
Free length after test is |
Caterpillar Information System:
C18 Generator Set Engines Fuel Pressure Sensor - Remove and Install
C18 Generator Set Engines Crankcase Pressure Sensor - Remove and Install
G3512 Generator Set Engines Sensor Signal (Analog, Active) - Test
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Alarms and Shutoffs
C18 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
XQP150 Rental Generator Set Setup
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Product Lifting
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Reference Information
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Emissions Certification Film
C18 Generator Set Engines Coolant Temperature Sender - Remove and Install
C18 Generator Set Engines Crankshaft Position Sensor - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Plate Locations and Film Locations
G3512 Generator Set Before Starting Engine
G3512 Generator Set Cold Weather Starting
G3512 Generator Set Emergency Stopping
C9.3 Marine Auxiliary and Generator Set Engine Speed Control - Test
G3512 Generator Set Refill Capacities
C18 Generator Set Engines Fuel Temperature Sensor - Remove and Install
General Troubleshooting Guidelines For Nitrite Levels For Certain Gas Engines {0769, 1000, 1352, 1395} General Troubleshooting Guidelines For Nitrite Levels For Certain Gas Engines {0769, 1000, 1352, 1395}
C18 Generator Set Engines Pressure Sensor (ARD Combustion Air) - Remove and Install
C18 Generator Set Engines Temperature Sensor (Catalyst Inlet) - Remove and Install
C9.3 Marine Auxiliary and Generator Set Engine Data Link - Test
C18 Generator Set Engines Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Belts - Inspect/Adjust/Replace