Connecting Rod Bearing Journal - Spheroidal Graphite Iron Crankshaft
The original size of the connecting rod bearing journal ... 67.99 mm (2.6768 inch)
Maximum permissible wear of a bearing journal on a new connecting rod ...
Width of the connecting rod bearing journals ...
Surface finish of connecting rod bearing journals and radii ...
The Shell for the Connecting Rod Bearings
Thickness at center of the shells ...
Width of the connecting rod bearing shells ...
Clearance between the bearing shell and the connecting rod bearing journals ...
Caterpillar Information System:
C4.4 Engines for Caterpillar Built Machines Crankshaft - Spheroidal Graphite Iron (SGI) Crankshaft
C280-08 Marine Engine Plate Locations and Film Locations
C280-16 Engine Alternator - Remove and Install
2014/03/31 A New Rear Engine Crankshaft Seal Is Now Used on Certain Excavators Equipped With C13 Engines {1161}
C175 Oil Pressure Regulator Inspection and Rework{1304, 5117} C175 Oil Pressure Regulator Inspection and Rework{1304, 5117}
C15 and C18 On-Highway Engines Engine Control Module - Remove and Install
C15 and C18 On-Highway Engines Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Remove and Install
2013/12/20 Improved Product Link Satellite System Special Instruction guide {7606}
TA2 Technical Inspection for 3512B Dynamic Gas Blending Genset Engines{1000, 1050, 1250, 1300, 1350, 1400} TA2 Technical Inspection for 3512B Dynamic Gas Blending Genset Engines{1000, 1050, 1250, 1300, 1350, 1400}
C15 and C18 On-Highway Engines Engine Oil Pan - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Water in Fuel - Test
C15 and C18 On-Highway Engines Vibration Damper and Pulley - Remove and Install
C4.4 Engines for Caterpillar Built Machines Main Bearing Journal - Spheroidal Graphite Iron (SGI) Crankshaft
C4.4 Engines for Caterpillar Built Machines Connecting Rod - For Use With Spheroidal Graphite Iron (SGI) Crankshaft
C280-16 Engine Crankcase Explosion Relief Valve - Remove and Install
C15 and C18 On-Highway Engines Front Cover - Remove and Install
A Procedure Is Available to Adapt the Glow Plug Harness to Certain Engines{1403, 1412} A Procedure Is Available to Adapt the Glow Plug Harness to Certain Engines{1403, 1412}
C15 and C18 On-Highway Engines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Differential Pressure
C11 and C13 On-Highway Engines Compression Brake Lash - Adjust
C15 and C18 On-Highway Engines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Outlet Pressure
C15 and C18 On-Highway Engines Boost Pressure Sensor - Remove and Install
C15 and C18 On-Highway Engines Inlet Air Temperature Sensor - Remove and Install
C15 and C18 On-Highway Engines Belt Tensioner - Remove and Install - Fan Belt Tensioner