Water Temperature Regulator - Remove and Install
拆卸步骤
开始:
- 拆下水温调节器壳体。 请参阅拆解和组装, "水温调节器壳体 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修发动机时,请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前,要准备好合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品,请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。 按照本地法规和条例处置所有液体。 |
- 将螺栓 (1) 和垫圈从出口管 (2) 上拆下。
Show/hide table
图 1 | g01262258 |
- 拆下出口管 (2) 和垫片 (3) 。
- 从水温调节器壳体 (5) 上拆下水温调节器 (4) 。
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 清洁水温调节器壳体的配合面。
- 将水温调节器 (4) 定位到水温调节器壳体 (5) 内。
Show/hide table
图 2 | g01262258 |
- 安装新垫片 (3) 和出口管 (2) 。
- 安装螺栓 (1) 和垫圈。 将螺栓 (1) 上紧到 28 ± 7 N·m (21 ± 5 lb ft) 的扭矩。
End By: 安装水温调节器壳体 3。 请参阅 拆解和组装, "水温调节器壳体 - 拆卸和安装"。
Caterpillar Information System:
C7 On-Highway Engine Rocker Shaft and Pushrod - Install
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3825 - FMI 8
C7 On-Highway Engine Rocker Shaft and Pushrod - Remove
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 191 - FMI 8
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 161 - FMI 8
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3027 - FMI 3
C7 On-Highway Engine Connecting Rod Bearings - Install
C7 On-Highway Engine Connecting Rod Bearings - Remove
C7 On-Highway Engine Pistons and Connecting Rods - Install
C7 PETROLEUM Petroleum Engine Air Inlet Heater - Remove and Install
2006/04/17 A New Impeller is Now Used in the Sea Water Pump of Marine Engines {1371}
3500B Industrial Engines with the ADEM 3 Electronic Control Module System Overview
CX28 On-Highway Transmission Drive Plate
C7 and C9 On-highway Engines Emissions Certification Film
CX31 On-Highway Transmission Oil Filter (Transmission)
C7 On-Highway Engine Fuel Injection Pump - Remove
C7 On-highway Engine Air Lines - Aftertreatment Regeneration Device
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electrical Connectors and Functions
725C, 725C2, 730C, 730C2 and 730C, 730C2 EJECTOR Articulated Truck Systems Gear Pump (Transmission)
C11 and C13 Petroleum Engines Rocker Arm - Disassemble
C11 and C13 Petroleum Engines Rocker Arm - Assemble
C9 On-highway Engine Engine Oil Pan
C7 On-Highway Engine Lifter Group - Remove and Install
C13 Engine Inlet and Exhaust Valve Springs - Remove and Install