Connecting Rod Bearings - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g01261959 |
Show/hide table
Illustration 2 | g01261956 |
- Install a new lower half of connecting rod bearing (4) in connecting rod bearing cap (2).
- Install a new upper half of connecting rod bearing (4) in connecting rod (3).
- Pull connecting rod (3) onto the crankshaft.
- Install connecting rod bearing cap (2) and bolts (1). Ensure that the number on the side of connecting rod bearing cap (2) is on the same side as the number on connecting rod (3).
- Tighten bolts (1) to a torque of
70 ± 5 N·m (52 ± 4 lb ft) . - Place an index mark on each bolt. Tighten each bolt (1) for an additional 120 ± 5 degrees (1/3 turn).
Note: Install connecting rod bearings (4) dry when clearance checks are performed. Refer to Disassembly and Assembly, "Bearing Clearance - Check". Apply clean engine oil on the connecting rod bearings for final assembly.
End By:
- Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".
Caterpillar Information System:
C7 On-Highway Engine Connecting Rod Bearings - Remove
C7 On-Highway Engine Pistons and Connecting Rods - Install
C7 PETROLEUM Petroleum Engine Air Inlet Heater - Remove and Install
2006/04/17 A New Impeller is Now Used in the Sea Water Pump of Marine Engines {1371}
3500B Industrial Engines with the ADEM 3 Electronic Control Module System Overview
C7 On-Highway Engine Pistons and Connecting Rods - Assemble
C9.3 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
C9.3 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
C15 On-Highway Engine Valve Actuator (Variable) - Install
C15 On-Highway Engine Valve Actuator (Variable) - Remove
C4.4 Industrial Engine Engine Oil Pan
C4.4 Industrial Engine Water Temperature Regulator and Housing
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3027 - FMI 3
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 161 - FMI 8
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 191 - FMI 8
C7 On-Highway Engine Rocker Shaft and Pushrod - Remove
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3825 - FMI 8
C7 On-Highway Engine Rocker Shaft and Pushrod - Install
C7 PETROLEUM Petroleum Engine Water Temperature Regulator - Remove and Install
CX28 On-Highway Transmission Drive Plate
C7 and C9 On-highway Engines Emissions Certification Film
CX31 On-Highway Transmission Oil Filter (Transmission)
C7 On-Highway Engine Fuel Injection Pump - Remove
C7 On-highway Engine Air Lines - Aftertreatment Regeneration Device