Connecting Rod Bearings - Remove
Start By:
- Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Turn the crankshaft until connecting rod bearing caps (2) are accessible.
- Place an identification mark on connecting rod (3) and connecting rod bearing cap (2). The number should match the cylinder number.
- Remove bolts (1) and connecting rod bearing cap (2) from connecting rod (3). Remove the lower half of connecting rod bearing (4) from connecting rod bearing cap (2).
- Push the connecting rod away from the crankshaft. Remove the upper half of connecting rod bearing (4) from connecting rod (3).
Show/hide table
Illustration 1 | g01261956 |
Show/hide table
Illustration 2 | g01261959 |
Caterpillar Information System:
C7 On-Highway Engine Pistons and Connecting Rods - Install
C7 PETROLEUM Petroleum Engine Air Inlet Heater - Remove and Install
2006/04/17 A New Impeller is Now Used in the Sea Water Pump of Marine Engines {1371}
3500B Industrial Engines with the ADEM 3 Electronic Control Module System Overview
C7 On-Highway Engine Pistons and Connecting Rods - Assemble
C9.3 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
C9.3 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
C15 On-Highway Engine Valve Actuator (Variable) - Install
C15 On-Highway Engine Valve Actuator (Variable) - Remove
C4.4 Industrial Engine Engine Oil Pan
C4.4 Industrial Engine Water Temperature Regulator and Housing
C4.4 Industrial Engine Belt Tension Chart
C7 On-Highway Engine Connecting Rod Bearings - Install
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3027 - FMI 3
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 161 - FMI 8
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 191 - FMI 8
C7 On-Highway Engine Rocker Shaft and Pushrod - Remove
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3825 - FMI 8
C7 On-Highway Engine Rocker Shaft and Pushrod - Install
C7 PETROLEUM Petroleum Engine Water Temperature Regulator - Remove and Install
CX28 On-Highway Transmission Drive Plate
C7 and C9 On-highway Engines Emissions Certification Film
CX31 On-Highway Transmission Oil Filter (Transmission)
C7 On-Highway Engine Fuel Injection Pump - Remove