Procedures To Resolve Certain Causes Of Low Drivetrain Power Caterpillar


Procedures To Resolve Certain Causes Of Low Drivetrain Power

Usage:

TRACK-TYPE LOADER953C (2ZN) TRACK-TYPE LOADER

Problem:

The machine does not reach full track speed, even after the S/D lever is incresed to 100%.

Solution:

1. Set the high idle to the proper specification. See Service Manual for procedure. Complaints of low power in the hydrostatic transmission can many times be traced to engine problems.
2. Perform the maximum track speed calibration procedure on page 145 of Service Manual SENR8314-01 "Hydrostatic Transmission additional warning lamp". Engineering is working on a permanent solution to this problem.

COPYRIGHT 1998 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

Removing Invalid Service Codes (MID 030, CID 511, FMI 55) Removing Invalid Service Codes (MID 030, CID 511, FMI 55)
Camshaft Injector Lifter (Roller Follower) Assembly Replacement Camshaft Injector Lifter (Roller Follower) Assembly Replacement
Damage To Hydraulic Hoses On Lift Circuit Damage To Hydraulic Hoses On Lift Circuit
Correct Machining Of The 130-9004 Intake Valve Seat Insert Correct Machining Of The 130-9004 Intake Valve Seat Insert
Final Drive Planet Bearings Final Drive Planet Bearings
Cracks May Occur In Push Arm Bearing Assembly Welds Cracks May Occur In Push Arm Bearing Assembly Welds
Wire Harness May Contact The Muffler Support Wire Harness May Contact The Muffler Support
Open Rops Heater Relay Open Rops Heater Relay
Air Conditioner Leaking Condensation Into Cab Air Conditioner Leaking Condensation Into Cab
Aftercooler Coolant Hose Clamps May Be Incorrectly Tightened Aftercooler Coolant Hose Clamps May Be Incorrectly Tightened
High Brass Readings In Power Train Oil System High Brass Readings In Power Train Oil System
Inspect Sprocket Segment Mounting Bolts Inspect Sprocket Segment Mounting Bolts
Air Conditioning Unit May Fall Off The Back Of The Cab On Some 953C Machines Air Conditioning Unit May Fall Off The Back Of The Cab On Some 953C Machines
New Hydraulic Electronic Control Improves Blade Control New Hydraulic Electronic Control Improves Blade Control
Noise In Differential Or Copper In Power-Train Oil Noise In Differential Or Copper In Power-Train Oil
Front Guard Changed To Prevent Interference With Tilt Cylinder Front Guard Changed To Prevent Interference With Tilt Cylinder
Engine Fan Drive Group Engine Fan Drive Group
Suggestions For Stocking Hoses Suggestions For Stocking Hoses
Front Wheel Assist May Not Come On For Wheel Type Asphalt Pavers Front Wheel Assist May Not Come On For Wheel Type Asphalt Pavers
D11 Track-Type Tractor CrN Track Bushing Available For Parts Service D11 Track-Type Tractor CrN Track Bushing Available For Parts Service
The 142-2882 Flow Control Valves May Cause Vibration And Noise In Transmission Hoses The 142-2882 Flow Control Valves May Cause Vibration And Noise In Transmission Hoses
Pre-Lube Switch Contacts Stick Pre-Lube Switch Contacts Stick
Transmissions Equipped With Electronic Clutch Pressure Controls (ECPC) Transmissions Equipped With Electronic Clutch Pressure Controls (ECPC)
Correction To Service Letter, PI3192, "The Software Needs To Be Updated On Certain 992G Wheel Loaders" Correction To Service Letter, PI3192, "The Software Needs To Be Updated On Certain 992G Wheel Loaders"
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.