1982/05/17 Caterpillar


Fuel Ratio Control Is Now Available As A Group{1278}

Usage:


All 3300 Series Engines With Direct Injection Scroll Fuel Systems Except Those in D4E, D5B &
D6D built in Japan.

SUPPLEMENT: 06/21/82

SERVICE MAGAZINE, MAY 17, 1982, PAGE 9. In the article, "Fuel Ratio Control Is Now Available As A Group," change the subtitle to read as follows: "All 3300 Series Engines With Direct Injection Scroll Fuel Systems Except Those in D4E, D5B and D6D Tractors Built In Japan".

--------------- END SUPPLEMENT ---------------

The 7N8622 Fuel Ratio Control Group which is used on the above engines is now available for parts service as a group. The separate components of this group are still available for parts service. Formerly, if a complete group was desired, the separate components had to be ordered and then assembled. To assemble the separate components, the serviceman had to use a fixture group, fuel injection test bench and a special adjustment procedure. Now that the fuel ratio control is available as a group and comes already adjusted, it will make service easier when it is necessary to make a replacement of the complete group.

Make a reference to the Fuel System Section of the Testing and Adjusting module in your Service Manual for the correct adjustment procedure for the fuel ratio control linkage after it is installed on the engine.

Caterpillar Information System:

1982/05/17 Improvements Made To 6V3000 Sure Seal Repair Kit{0611,1408}
1982/05/17 Larger Studs Can Be Used With Rear Exhaust Manifolds{1059}
1982/05/17 Wrong Water Separator Element Will Not Remove Water{1263}
1982/05/17 Holes Added To Water Pump Impeller{1361}
1982/05/10 Two-Piece Guard For Alternator Fan And Belts{1400}
1982/05/10 Fuel Rack Slots Have Improved Wear Resistance{1257}
1982/05/10 Be Sure To Use Correct Water Temperature Regulators{1355}
1982/05/10 5P3519 Gauge Group Components Available Separately{0653,1215}
1982/05/10 5P4812 Gauge Group Components Available Separately{0653,1215}
1982/05/10 New Mounting Bracket For Mechanical Shut-Off Cable{7418}
1982/05/10 New Crankshaft Main Bearings Used{1203}
1982/05/10 New Exhaust Tubes And Support Used{1061,1067}
1982/05/24 New Auxiliary Pump Group Operates At A Slower RPM{1371}
1982/05/24 New Seal Used In Turbocharger Mounting; Check Mount Casting For Clearance{1052}
1982/05/31 Improved Water Separator Group Used {1263}
1982/05/31 Separate Serial Numbers For 3208 Remanufactured Engines {1000}
1982/06/07 Separate Valve Stem Gauges Available{0653,1000}
1982/06/07 List Of Main And Connecting Rod Bearings Currently Available{1203,1219,1230,1226,1227}
1982/06/07 Use Correct Torque On Hydraulic Fittings{7554,5057}
1982/06/07 Identification Numbers For Caterpillar Partial Machines{0300}
1982/06/14 Stronger Turbine Wheel Used In Turbocharger Shaft And Wheel Assemblies{1053,1052}
1982/06/14 Improvements Made To Input Shaft Group{3303}
1982/06/14 New Address For Repair Of Diagnostic Tools{0650}
1982/06/21 Hose Presses Can Now Be Used To Install JIC Couplings{0623,7554,0624}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.