Potentiometers
Potentiometer (Speed Control)
Show/hide table
 | |
| Illustration 1 | g00792764 |
Potentiometer for the speed control | |
The speed control potentiometer provides local adjustment of engine speed.
The speed control uses a 10-turn potentiometer that has 5000 Ohms of resistance.
The potentiometer is used with the E30 governor control. An increase in the resistance will cause the engine speed to increase.
Potentiometer (Speed Control)
Show/hide table
 | |
| Illustration 2 | g00792765 |
Potentiometer for the speed control | |
The speed control potentiometer provides local adjustment of engine speed.
The speed control uses a 10-turn potentiometer that has 200 Ohms of resistance.
The potentiometer is used with the 2301A governor control. An increase in the resistance will cause the engine speed to increase.
Caterpillar Information System:
3406E Generator Set Engines Starting the Engine
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Indicators
Electronic Modular Control Panel II+ (EMCP II+) EMCP Electronic Control (Generator Set)
Air Conditioning and Heating R134a for All Caterpillar Machines Electronic Heat Control - Test
Product Identification Numbers (PIN) Location Guide Ripper
Product Identification Numbers (PIN) Location Guide Bulldozer
Electronic Modular Control Panel II+ (EMCP II+) Data Link
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Solenoids
3412C Engine Inlet and Exhaust Valves - Remove and Install
XQ300, XQ400 Rental Generator Sets Control Panel
2001/05/01 A New Special Instruction, REHS1026-00, "Installation And Callibration Of The 144-0441 Tachometer " Is Available {7462, 7462}
3412C Engine Engine Oil Pan - Remove and Install
3034 Marine Engine Model View Illustrations
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Sensors
3606, 3608, 3612, 3616 and 3618 Engines Tachometer General Information
3412C Engine Flywheel - Install
G3600 Engines Emergency Stopping
Electronic Modular Control Panel II+ (EMCP II+) Service Mode
3412C Engine Flywheel - Remove
3034 Marine Engine Alternator Belt - Inspect/Adjust/Replace
Electronic Modular Control Panel II+ (EMCP II+) Modes Of Operation
3412C Engine Cylinder Head - Install
Electronic Modular Control Panel II+ (EMCP II+) Engine/Generator Programming OP5-0
Electronic Modular Control Panel II+ (EMCP II+) Normal Mode