Flywheel - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Description     | Qty     |
A     | 138-7575     | Link Bracket     | 1     |
B     | 2P-2506     | Thread Compound     | 1     |
- Heat gear (1) to a maximum temperature of 315 °C (600 °F). Install gear (1) on the flywheel. The chamfer must be on the side of the flywheel that is toward the crankshaft.
Show/hide table
Illustration 1 | g00792827 |
- Fasten Tool (A) to the flywheel. Put a guide bolt (2) in the crankshaft. Install flywheel (3) . The weight of the flywheel is approximately 56 kg (123 lb).
Show/hide table
Illustration 2 | g00792840 |
Typical Example. Tooling (A) shown is not the tooling called out in the Table. |
- Apply Tooling (B) on the threads of the bolts that fasten the flywheel to the crankshaft. Install the bolts. Tighten the bolts to a torque of 360 ± 25 N·m (266 ± 18 lb ft).
Caterpillar Information System:
3606, 3608, 3612, 3616 and 3618 Engines Tachometer General Information
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Sensors
3034 Marine Engine Model View Illustrations
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Potentiometers
3406E Generator Set Engines Starting the Engine
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Indicators
Electronic Modular Control Panel II+ (EMCP II+) EMCP Electronic Control (Generator Set)
Air Conditioning and Heating R134a for All Caterpillar Machines Electronic Heat Control - Test
Product Identification Numbers (PIN) Location Guide Ripper
Product Identification Numbers (PIN) Location Guide Bulldozer
Electronic Modular Control Panel II+ (EMCP II+) Data Link
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Solenoids
G3600 Engines Emergency Stopping
Electronic Modular Control Panel II+ (EMCP II+) Service Mode
3412C Engine Flywheel - Remove
3034 Marine Engine Alternator Belt - Inspect/Adjust/Replace
Electronic Modular Control Panel II+ (EMCP II+) Modes Of Operation
3412C Engine Cylinder Head - Install
Electronic Modular Control Panel II+ (EMCP II+) Engine/Generator Programming OP5-0
Electronic Modular Control Panel II+ (EMCP II+) Normal Mode
3034 Marine Engine Cooling System Coolant (DEAC) - Change
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Speed Sensor - Adjust
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Component Location
2001/05/01 New Valve Guides Are Used {1104}