Engine Oil Pan - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Drain the oil from the oil pan.
Show/hide table
Illustration 1 | g00797083 |
- Remove bolts (1) from the oil pan. Remove the oil pan. The weight of the oil pan is 27 kg (60 lb).
Installation Procedure
- Put a new gasket into position on the oil pan. Put the oil pan in position on the engine.
- Install the bolts (1) that hold the oil pan to the engine.
- Fill the engine with engine oil. Refer to the Operation and Maintenance Manual.
Caterpillar Information System:
Product Identification Numbers (PIN) Location Guide Bucket
Electronic Modular Control Panel II+ (EMCP II+) General Information
XQ300, XQ400 Rental Generator Sets Cold Weather Starting
Product Identification Numbers (PIN) Location Guide Wheel Tractor-Scraper
Product Identification Numbers (PIN) Location Guide Track-Type Skidder
Product Identification Numbers (PIN) Location Guide Motor Grader
3500B and 3500B High Displacement Generator Set Engines System Overview
3412C Engine Aftercooler - Remove and Install
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Detectors
3412C Engine Vibration Damper and Pulley - Remove and Install
Product Identification Numbers (PIN) Location Guide Pipelayer
2001/05/01 Be Sure To Tighten The Locknut For The Adjusting Screw For The Fuel Injector Rocker Arm To The Correct Torque {1290}
2001/05/01 A New Special Instruction, REHS1026-00, "Installation And Callibration Of The 144-0441 Tachometer " Is Available {7462, 7462}
XQ300, XQ400 Rental Generator Sets Control Panel
3412C Engine Inlet and Exhaust Valves - Remove and Install
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Solenoids
Electronic Modular Control Panel II+ (EMCP II+) Data Link
Product Identification Numbers (PIN) Location Guide Bulldozer
Product Identification Numbers (PIN) Location Guide Ripper
Air Conditioning and Heating R134a for All Caterpillar Machines Electronic Heat Control - Test
Electronic Modular Control Panel II+ (EMCP II+) EMCP Electronic Control (Generator Set)
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Indicators
3406E Generator Set Engines Starting the Engine
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Potentiometers