Flywheel - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 138-7575     | Link Bracket     | 1     |
- Fasten Tool (A) to flywheel (2) . Remove bolts (1) and flywheel (2) from the crankshaft. The weight of the flywheel is approximately 56 kg (123 lb).
Show/hide table
Illustration 1 | g00792883 |
Typical Example. Tooling (A) that is shown is not what is being called out in the Table. |
- Remove gear (3) from the flywheel if the gear must be replaced.
Show/hide table
Illustration 2 | g00792926 |
Caterpillar Information System:
Electronic Modular Control Panel II+ (EMCP II+) Service Mode
G3600 Engines Emergency Stopping
3412C Engine Flywheel - Install
3606, 3608, 3612, 3616 and 3618 Engines Tachometer General Information
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Sensors
3034 Marine Engine Model View Illustrations
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Potentiometers
3406E Generator Set Engines Starting the Engine
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Indicators
Electronic Modular Control Panel II+ (EMCP II+) EMCP Electronic Control (Generator Set)
Air Conditioning and Heating R134a for All Caterpillar Machines Electronic Heat Control - Test
Product Identification Numbers (PIN) Location Guide Ripper
3034 Marine Engine Alternator Belt - Inspect/Adjust/Replace
Electronic Modular Control Panel II+ (EMCP II+) Modes Of Operation
3412C Engine Cylinder Head - Install
Electronic Modular Control Panel II+ (EMCP II+) Engine/Generator Programming OP5-0
Electronic Modular Control Panel II+ (EMCP II+) Normal Mode
3034 Marine Engine Cooling System Coolant (DEAC) - Change
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Speed Sensor - Adjust
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Control Panel Component Location
2001/05/01 New Valve Guides Are Used {1104}
Electronic Modular Control Panel II+ (EMCP II+) Protective Relaying Programming OP5-1
Electronic Modular Control Panel II+ (EMCP II+) Hourmeter Programming OP7
Electronic Modular Control Panel II+ (EMCP II+) Alarm Mode