Carburetor - Disassemble - High Pressure
Start By:
- Remove the carburetor. Refer to Disassembly and Assembly, "Carburetor - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove adapter (1) and the gasket from base (2).
Show/hide table
Illustration 2 g00597238 Typical example Show/hide tablePersonal injury can result from parts and/or covers under spring pressure.
Spring force will be released when covers are removed.
Be prepared to hold spring loaded covers as the bolts are loosened.
- Remove the screws, cover (5), spring (4), and air valve assembly (3).
Show/hide table
Illustration 3 g00597239 Typical example - Remove screws (6) and diaphragm (7).
Show/hide table
Illustration 4 g00597284 Typical example - Remove the setscrews and disc (10) from shaft (11).
- Loosen the bolt and remove lever (8).
- Loosen the set screw and remove stop assembly (9). Remove shaft (11).
Show/hide table
Illustration 5 g00597280 Typical example - Remove the screws and mixer housing (12).
- Remove the bolts and base (13) from throttle assembly (14).
Show/hide table
Illustration 1 | g00597237 |
Typical example |
Caterpillar Information System:
G3606 and G3608 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - Low Pressure
G3500 Engines Carburetor - Install - High Pressure
G3500 Engines Carburetor - Remove - Low Pressure
3524B Engine for Caterpillar Built Machines Crankcase Breather - Remove and Install
3500B Engines Exhaust Elbow - Remove and Install
G3606 and G3608 Engines Junction Box (Hydrax) - Remove and Install
G3500 Engines Carburetor - Remove - Low Pressure
G3500 Engines Carburetor - Remove - High Pressure
3064 and 3066 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
G3500 Engines Exhaust Elbow - Remove and Install
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Harness Code - Troubleshoot
G3606 and G3608 Engines Hydraulic Tank (Hydrax) - Remove and Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Front Housing and Covers
3500B Engines Air Starting Motor - Remove
G3500 Engines Carburetor - Assemble - High Pressure
G3500 Engines Carburetor - Disassemble - High Pressure
3500B Engines and 3500 Engines with EUI Option Emergency Stop Switch
3034 Engine for Caterpillar Built Machines Turbocharger - Install
G3500 Engines Carburetor - Assemble - High Pressure
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Gear Group (Front)
G3500 Engines Electronic Sensor - Remove and Install
Electronic Modular Control Panel II (EMCP II) For PEEC Engines CID 331 FMI 2 Switch (Engine Control) Incorrect Signal - Test