Alternator - Remove and Install
Removal Procedure
Show/hide table
 |
Disconnect batteries before performance of any service work. |
 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put identification marks on wires (1) for the alternator. Disconnect wires (1) from the alternator.
Show/hide table
 | |
| Illustration 1 | g00491140 |
- Loosen bolts (3) and (4). Remove belts (5) from the alternator. Remove bolts (3) and (4) from alternator (2) .
Show/hide table
 | |
| Illustration 2 | g00492683 |
Typical example | |
- Remove alternator (2) .
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put alternator (2) in position and install bolt (4) finger tight. Put belt (5) in position on the pulleys and install bolt (3). Tighten bolt (4) .
Show/hide table
| | |
| Illustration 3 | g00492683 |
Typical example | |
- Apply tension to belt (5) and tighten bolt (3). Use a belt tension gauge to measure the belt farthest from the engine. Tighten new belts to 534 ± 22 N (120 ± 5 lb). Tighten used belts to 400 ± 44 N (90 ± 10 lb).
- connect wires (1) to the alternator.
Show/hide table
| | |
| Illustration 4 | g00491140 |
Caterpillar Information System:
3306B Industrial Engine Electric Starting Motor - Remove and Install
3306B Industrial Engine Troubleshooting
3304B and 3306B Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
3306B Industrial Engine Fuel Ratio Control
3304B and 3306B Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
G3612 and G3616 Engines Engine Timing Procedures
C-10 and C-12 Truck Engines Rear Power Take-Off (RPTO)
G3612 and G3616 Engines Governor Adjustment Procedure
3406C (PEEC III) Truck Engine Engine Support (Front)
3304B and 3306B Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
3600 and C280 Diesel Engine Fluids Recommendations Heavy Fuel Oil
3406C Engines for Caterpillar Built Machines Exhaust Manifold Shield
3306B Industrial Engine Fuel Injection Lines
G3612 and G3616 Engines Engine Supervisory System
Electronic Modular Control Panel II (EMCP II) for EUI Engines Service Record
G3612 and G3616 Engines Ignition System
3406C (PEEC III) Truck Engine Manual Shutoff
3306B Industrial Engine Gear Group (Front)
3306B Industrial Engine Fuel System
3406C (PEEC III) Truck Engine Governor and Fuel Pump Drive
3406C (PEEC III) Truck Engine Timing Position Sensor and Timing Solenoid (BTM)
3406C (PEEC III) Truck Engine Fuel Rack Controls
3406E Truck Engines Engine Design
Electronic Modular Control Panel II (EMCP II) For MUI Engines General Information