Electric Starting Motor - Remove and Install
Removal Procedure
Show/hide table
 |
Disconnect batteries before performance of any service work. |
 |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put identification marks on the wires for the electric starting motor. Disconnect wires (3) from the electric starting motor.
Show/hide table
 | |
| Illustration 1 | g00492787 |
- Use two technicians to remove electric starting motor (2). The weight of the electric starting motor is 29 kg (64 lb). Remove three bolts (1) and electric starting motor (2) from the flywheel housing. Check the condition of the gasket for the electric starting motor. If the gasket is worn or damaged, use new parts for replacement.
Show/hide table
|
Personal injury or death can result from lifting a heavy assembly. The heavy assembly can fall if using an incorrect hoist to lift the load. Be sure the hoist has the correct capacity to lift a heavy assembly. Approximate weight of the body assembly is given below. |
|
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Put the gasket and electric starting motor (2) in position on the flywheel housing. Install three bolts (1) .
Show/hide table
| | |
| Illustration 2 | g00492787 |
- connect wires (3) to the electric starting motor.
Caterpillar Information System:
3306B Industrial Engine Troubleshooting
3304B and 3306B Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
3306B Industrial Engine Fuel Ratio Control
3304B and 3306B Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
G3612 and G3616 Engines Engine Timing Procedures
C-10 and C-12 Truck Engines Rear Power Take-Off (RPTO)
G3612 and G3616 Engines Governor Adjustment Procedure
3406C (PEEC III) Truck Engine Engine Support (Front)
3304B and 3306B Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
3600 and C280 Diesel Engine Fluids Recommendations Heavy Fuel Oil
3406C Engines for Caterpillar Built Machines Exhaust Manifold Shield
G3612 and G3616 Engines Choke Trim
3306B Industrial Engine Alternator - Remove and Install
3306B Industrial Engine Fuel Injection Lines
G3612 and G3616 Engines Engine Supervisory System
Electronic Modular Control Panel II (EMCP II) for EUI Engines Service Record
G3612 and G3616 Engines Ignition System
3406C (PEEC III) Truck Engine Manual Shutoff
3306B Industrial Engine Gear Group (Front)
3306B Industrial Engine Fuel System
3406C (PEEC III) Truck Engine Governor and Fuel Pump Drive
3406C (PEEC III) Truck Engine Timing Position Sensor and Timing Solenoid (BTM)
3406C (PEEC III) Truck Engine Fuel Rack Controls
3406E Truck Engines Engine Design