Timing Position Sensor and Timing Solenoid (BTM)
Show/hide table
Illustration 1 | g00491838 |
(1) Timing solenoid (BTM)
(2) 4B-4909 Spring
- Length under test force ... 11.9050 mm (.4687 inch)
- Test force ... 67 ± 4 N (15 ± 1 lb)
- Free length after test ... 19.05 mm (.750 inch)
- Outside diameter ... 24.701 mm (.9725 inch)
- Test force ... 67 ± 4 N (15 ± 1 lb)
(3) Timing Sensor
Note: Refer to Systems Operation/Testing and Adjusting, "Timing Position Sensor Calibration" for the correct calibration procedure.
(4) Nut
- After calibration, tighten the nut to the following torque. ... 55 ± 7 N·m (41 ± 5 lb ft)
(5) O-ring seal
Show/hide table
Illustration 2 | g00491840 |
(6) Bellcrank
Note: Rotate the bellcrank through a distance of 190 degrees in order to wind the spring (7) before assembly. Latch the bellcrank with the pin.
(7) 2W-3627 Spring
- Type ... Torsion spring
- Rate per 360 degrees ... 1.164 N·m (10.302 lb in)
- Assembled load at 180 degrees deflection ... 0.582 N·m (5.15 lb in)
- Rate per 360 degrees ... 1.164 N·m (10.302 lb in)
Caterpillar Information System:
3406C (PEEC III) Truck Engine Governor and Fuel Pump Drive
3306B Industrial Engine Fuel System
3306B Industrial Engine Gear Group (Front)
3406C (PEEC III) Truck Engine Manual Shutoff
G3612 and G3616 Engines Ignition System
Electronic Modular Control Panel II (EMCP II) for EUI Engines Service Record
G3612 and G3616 Engines Engine Supervisory System
3306B Industrial Engine Fuel Injection Lines
3306B Industrial Engine Alternator - Remove and Install
3306B Industrial Engine Electric Starting Motor - Remove and Install
3306B Industrial Engine Troubleshooting
3304B and 3306B Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
3406C (PEEC III) Truck Engine Fuel Rack Controls
3406E Truck Engines Engine Design
Electronic Modular Control Panel II (EMCP II) For MUI Engines General Information
3406E Truck Engine Valve Mechanism
Electronic Modular Control Panel II (EMCP II) General Information
3304B and 3306B Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
3306B Industrial Engine Engine Description
G3612 and G3616 Engines Ignition System
3406E Truck Engines Engine Oil Pan
3406E Truck Engines Cylinder Liner
3406E Truck Engine BrakeSaver Engine Oil Filter Base
Installation of 7C-6208 Cylinder Sleeve {1222} Installation of 7C-6208 Cylinder Sleeve {1222}