Electronic Unit Injector
Show/hide table
Illustration 1 | g01302098 |
(1) Torque for the bolt ... 55 ± 10 N·m (40 ± 7 lb ft)
(2) Lubricate the O-ring seals and the bore with a 50 percent mix of 8T-2998 Lubricant and clean engine oil.
Caterpillar Information System:
C9 Engine for Caterpillar Built Machines Cylinder Head - Remove
C9 Engine for Caterpillar Built Machines Turbocharger - Install
C13 On-highway Engine Front Housing and Covers
C9 Engine for Caterpillar Built Machines Turbocharger - Remove
C15 On-Highway Engine Crankshaft
C9 Generator Set Model View Illustrations
C9 Generator Set Plate Locations and Film Locations
C13 On-highway Engine Engine Oil Filter Base
C9 Generator Set Safety Messages
C15 On-Highway Engine Camshaft
349F and 352F Excavators Machine System Specifications Travel Counterbalance Valve
C2.2 Generator Sets Control Panel
2006/02/06 A New Exhaust Manifold Gasket is Used {1059}
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Rocker Arm
C2.2 Generator Sets Starting the Engine
C15 and C18 Engines for Caterpillar Built Machines Valve Rocker Arm
C15 and C18 Engines for Caterpillar Built Machines Gear Group (Front)
C9 Engine for Caterpillar Built Machines Cylinder Head - Install
C-10 Petroleum Engine Engine Oil Pump - Remove
C280 Marine and Petroleum Engines Engine Speed/Timing Sensor
C3.3 and C4.4 Rental Generator Sets Stopping the Engine
C6.6 Industrial Engine Introduction
C-10 Petroleum Engine Engine Oil Pump - Disassemble
Filtration Procedure for Hydraulic Oil in Compact Equipment {0680, 0768, 5050, 5056} Filtration Procedure for Hydraulic Oil in Compact Equipment {0680, 0768, 5050, 5056}